To clarify... this is for a PC with a single x16 slot which will have one GPU and then a single x1 slot which I want to run two more from using the splitter. I am not trying for 6+ or anything like that.
I want to use some cheap / older office PCs and simply swap the power supply and run 3x GPUs on them.
Topic: 2 RX 470 in one pci-e slot by PCI-e Exp 1X to 3 Port 1X Switch Multiplier HUB (Read 496 times)
May 24, 2017, 06:18:48 AM
May 24, 2017, 05:15:55 AM
Anyone use this ? I am currently searching old threads... I am interesting in using one of these to run 2x GPUs.
December 21, 2016, 09:16:12 PM
Hassle-free installation readme and order here ebay=>>http://tinyurl.com/gmclx9nIf you need more than one PCI-E x1 slot on the motherboard was not any so much, it touches you can think about it. It consists of two parts, one main card, interface installed via PCI-E X1 on the motherboard, two equipment cards, both of which are connected together via USB 3.0 cable.
The device card also uses the United States Pericom Pericom PI7C9X bridge chip, for switching PCI-E, PCI-E between.
But even USB 3.0, but also the theoretical bandwidth 5Gbps (625MB / s), one Into four Then remove the loss would only 150MB / s, and even PCI-E 1.x single-channel bandwidth also has 250MB / s, So this stuff more than enough to give you the best slots, there will not be enough bandwidth, not only for the performance requirements of the place. Therefore, the transferred PCI-E slot is the best version above 2.0, the 3.0 version is better.
Several Divided PCI-E 1X slot all is gen2 mode, even if gen1 previously ,it can be ok
The device card also uses the United States Pericom Pericom PI7C9X bridge chip, for switching PCI-E, PCI-E between.
But even USB 3.0, but also the theoretical bandwidth 5Gbps (625MB / s), one Into four Then remove the loss would only 150MB / s, and even PCI-E 1.x single-channel bandwidth also has 250MB / s, So this stuff more than enough to give you the best slots, there will not be enough bandwidth, not only for the performance requirements of the place. Therefore, the transferred PCI-E slot is the best version above 2.0, the 3.0 version is better.
Several Divided PCI-E 1X slot all is gen2 mode, even if gen1 previously ,it can be ok
Features:
2 layer PCB bard designing.
Compliant with PCI express 2.0, 1.1 Specification
1-slot PCI-E 1X to 3 slot 1X riser card with high speed USB 3.0 cable.
High speed USB 3.0 shield cable is flexible for 1U,2U,3U chassis.
Support 3 port high speed PCIe 1X card.
Solid capacitor provide extra stable power supply for PCI-e card
Mainboard size:(L*W*H)9.70*6.30*1.30cm/3.82"*2.48"*0.51"
PCI-E Card size:(L*W*H)11.90*6.60*1.90cm/4.69"*2.60"*0.75"
USB cable length：0.55m/1.8ft
Quantity:1set
Recommended for 2 GPU per riser.
Jump to: