AntMiner Dual Blade S1 Factory Reset

GordonBM

full member

Activity: 137

Merit: 100

Turn it on.
Let it sit there for a while till you see it's trying to mine.
Press reset button for 3 sec. All lights will go out for a second.
When they turn on, kill the power.
Wait a second.
Turn it back on.

Now wait again for 20 seconds or so, because it takes time to boot the Antminer OS.

Now remote into it.

w00tcoin

member

Activity: 98

Merit: 10

w00t!coin

I held it down ... then powered the machine off while it was held down.

Then powered the machine on while it was held down.

Like a router.

ektakrome

newbie

Activity: 4

Merit: 0

So how long did you hold the reset button down for? I held mine down for a 30 count. then I did one where I held it down as I was powering it back on. Now I don't see lights coming on for the ethernet cable. This stinks.

w00tcoin

member

Activity: 98

Merit: 10

w00t!coin

NM fixed it ... I found out that it resets the machine to 192.168.1.99 and it worked!!!

The reason it was hot is ... because the old pool settings were still in the miner config.

fml

So yeah if anyone hits that reset button try to go to 192.168.1.99 and you should be good to go taco bell.

w00tcoin

member

Activity: 98

Merit: 10

w00t!coin

I see the button - I tried to hold it down and then power off to reset the machine.

But it does not work.

Can anyone help?

Do you know in what order, how long, what I need to do with the reset button to get the machine to reset to factory.

Thanks.

I screwed something up with one of the two AntMiners and now I cannot remote in to it.

It is powering on - seems to even be getting hot like it is mining - but I cannot remote in to it.

Also, this one was getting a LOT of HW errors.

That is why I tried to reset it (via gui reset option) and now it's not working.

Topic: AntMiner Dual Blade S1 Factory Reset (Read 4261 times)