Author

Topic: AntMiner not recognized on network after power failure; only after soft reset (Read 661 times)

legendary
Activity: 1190
Merit: 1000
You can try using openwrt for your router. What is your router brand & type?
Yes, I'm thinking it is a router issue; I am using OpenWrt. Rebooting the router didn't help, either.

Ahh, hardware problem. Try to change the power supply if you had similar one.
sr. member
Activity: 507
Merit: 253
You can try using openwrt for your router. What is your router brand & type?
Yes, I'm thinking it is a router issue; I am using OpenWrt. Rebooting the router didn't help, either.
legendary
Activity: 1190
Merit: 1000
I'm using static IP on the miners, with everything (subnet, gateway, etc. addresses) set correctly.

I see, probably problem on your router. You can try using openwrt for your router. What is your router brand & type?
sr. member
Activity: 507
Merit: 253
I'm using static IP on the miners, with everything (subnet, gateway, etc. addresses) set correctly.
legendary
Activity: 1190
Merit: 1000
You can use dhcp binding feature on router to lock your ip address if using dynamic address.
legendary
Activity: 4256
Merit: 8551
'The right to privacy matters'
ALSO  ARE you using wifi in any spot along the network?  Spring means more wifi drop outs. Thunder storms drop out wifi and you could have trouble until you fully reset it.
legendary
Activity: 1456
Merit: 1000
Whenever my S5 powers down and is re-powered up, I cannot connect via its IP address. However, when I reset it (with a paperclip), my router finds it. Why is this?

are you using dchp

I'm guessing so.  When it powers down I would say it's grabbing a new IP when it comes back.  And when a soft reset its keeping IP.

I could be wrong as I always use static IP's.
legendary
Activity: 4256
Merit: 8551
'The right to privacy matters'
Whenever my S5 powers down and is re-powered up, I cannot connect via its IP address. However, when I reset it (with a paperclip), my router finds it. Why is this?

are you using DHCP or is it disabled? go to your settings under

 network

lan   check the DHCP SETTING
sr. member
Activity: 507
Merit: 253
Whenever my S5 powers down and is re-powered up, I cannot connect via its IP address. However, when I reset it (with a paperclip), my router finds it. Why is this?
Jump to: