Antminer S1 configuration HELP!!!! | Bitcointalksearch.org

kevin1234a

legendary

Activity: 1162

Merit: 1000

Decentralizing Jesus on the Blockchain

Sine you had mention this thing i wonder may be im not using right cables can you have a look to this post and advise may i need different cables to connect with psu thanks

https://bitcointalksearch.org/topic/m.7903797

jonnybravo0311

legendary

Activity: 1344

Merit: 1024

Mine at Jonny's Pool

Quote from: kevin1234a on July 19, 2014, 02:05:22 AM

Quote from: Hektur on July 19, 2014, 12:39:55 AM

it looks like you only have 1 blade mining. Check the cable running from the controller board to blade 2 to make sure they are plugged in all the way and check your power cable to also make sure it's seated right. Lower on the Miner Status page, what is it showing for Chain #2? Does it show any ASIC number or any x's?

Asic status for chain 1 and 2 is xoxoxoxo xoxoxoxo xoxoxoxo

Both of your blades show that? Do you have enough power running to it? What that status means is that every other ASIC is dead. This is why you're seeing about half the rate you should be getting. Definitely power it down and unplug the PCI-e cables. Check the unit for any obvious signs of damage like scorch marks or bent/broken pins. In addition to that, check your PSU and its cables. Make sure your PSU is actually able to provide the 360W the S1 needs, and that each of the 2 PCI-e plugs is actually providing it.

kevin1234a

legendary

Activity: 1162

Merit: 1000

Decentralizing Jesus on the Blockchain

Quote from: Hektur on July 19, 2014, 12:39:55 AM

it looks like you only have 1 blade mining. Check the cable running from the controller board to blade 2 to make sure they are plugged in all the way and check your power cable to also make sure it's seated right. Lower on the Miner Status page, what is it showing for Chain #2? Does it show any ASIC number or any x's?

Asic status for chain 1 and 2 is xoxoxoxo xoxoxoxo xoxoxoxo

Hektur

member

Activity: 271

Merit: 10

it looks like you only have 1 blade mining. Check the cable running from the controller board to blade 2 to make sure they are plugged in all the way and check your power cable to also make sure it's seated right. Lower on the Miner Status page, what is it showing for Chain #2? Does it show any ASIC number or any x's?

kevin1234a

legendary

Activity: 1162

Merit: 1000

Decentralizing Jesus on the Blockchain

Need help in configuring Antminer S1 to achieve its normal hash rate

worker 2 is rockminer which is showing its average hash
worker 1 is Antminer S1 and it is not touching 150 even
ghash is cloud miner ( i am not worried about it)

i couldn't figure out what difficulty level i have to set for each worker especially Antminer (worker1)? below is the pic for antminer status page as well. Do i have to change any setting for Antminer so at least it reach to 150 Ghs.

thanks

Topic: Antminer S1 configuration HELP!!!! (Read 2048 times)