Gratz, happy mining
Topic: Antminer S1 not mining (Read 1502 times)
Gratz, happy mining
It's finally working! Thank you so much!
http://gyazo.com/0e72b60ebd540d4d6c66126f94d4ab17
http://gyazo.com/0e72b60ebd540d4d6c66126f94d4ab17
Ok. found wrong setting.
Ip is 192.168.0.99
Gateway should be 192.168.0.1
Broadcasts should be 192.168.0.255
DNS should be 192.168.0.1
Then add second DNS 8.8.8.8
Your router address is 192.168.0.1 right?
Still not getting anything...
Could you post network setting page?
Still not getting anything...
my password for my pools is x .
Try to change it to 123. Some pool didn't accept x as password.
my password for my pools is x .
The password not "X" right?
I don't know what wrong with your S1.
Ok that weird. No board detected. Check if there is any loose connection from controller to hashing board.
Pool info also blank too. Could you please post miner configuration page?
Which would be where?
So, I have set everything up again but its still not mining? Don't know why.
Could you post the screen shot of cgminer status page?
So, I have set everything up again but its still not mining? Don't know why.
Is there anything i can do to reset it not in the software?
I saw this post
https://bitcointalksearch.org/topic/m.6470820
I saw this post
https://bitcointalksearch.org/topic/m.6470820
Try the S2 button & see what happen.
Is there anything i can do to reset it not in the software?
I saw this post
https://bitcointalksearch.org/topic/m.6470820
I saw this post
https://bitcointalksearch.org/topic/m.6470820
Ahh, wrong version, sorry.
The reset button is S2 button.
This is the procedure https://www.bitmaintech.com/files/download/AntMiner%20S1%20FAQ.pdf
Could you explain where the reset button is becasue i cant seem to find any good explainations...
Near ethernet port(on the right there is a hole) if i am not mistake.
Could you explain where the reset button is becasue i cant seem to find any good explainations...
It's a Corsair CX500M. Also i changed a setting in the network tab on the miner for the ethernet from WAN to LAN and now i can't access it. Please help!
Put some load on 5V rail, like old cd rom.
Try to reset the miner. Push & hold the reset button.
It's a Corsair CX500M. Also i changed a setting in the network tab on the miner for the ethernet from WAN to LAN and now i can't access it. Please help!
I have recently just got a antminer s1. After setting everything up like pool info etc. the miner just won't mine. I have left it for 1 hour and still no results. I'm using a 500w power supply, could this be the problem?
Thanks,
Thanks,
S1 power consumption is 360watt. What is you psu brand & type?
I have recently just got a antminer s1. After setting everything up like pool info etc. the miner just won't mine. I have left it for 1 hour and still no results. I'm using a 500w power supply, could this be the problem?
Thanks,
Thanks,
Jump to: