Topic: Antminer S1 Status/Miner Status/Antminer/This section contains no values yet (Read 1634 times)
October 05, 2014, 09:40:23 PM
Try to reset it to factory settings - the controller should have a little button on it. Click that and let the machine run for a few seconds and then reboot. Hopefully that fixes the problem.
October 05, 2014, 06:24:12 PM
Was it working before updating firmware?
October 05, 2014, 05:02:34 PM
My Antminer S1 was not working one day, and I tried everything to get it to start hashing again... Flashed the bios with the latest greatest, 20140207, it seems to be running, but not hashing... I go to the Miner Status page, and it gives me Pools (minus my Secondary) and Summary, just nothing in the Antminer section where the Circles or X's and Temps would be... and says "This section contains no values yet"
I have three miners, and when I change out the little Lan board everything works fine again, so its not the chip boards... it seems to be the little Lan board itself... can I get a new one, or what is the best way to fix this one? should I try an older Bios flash? or is it just trash?
I have three miners, and when I change out the little Lan board everything works fine again, so its not the chip boards... it seems to be the little Lan board itself... can I get a new one, or what is the best way to fix this one? should I try an older Bios flash? or is it just trash?
Jump to: