just updating my debug so far
swapping SD card didn't make any difference
swapping the beagleboard worked
so on the good beagleboard two Ethernet led's status-- yellow is solid and green is blinking fast
so on the bad beagleboard two ethernet led's status-- yellow and green both are blinking at around 1 second interval
any help guys what i should do next
Topic: Antminer S2 wont communicate (Read 1031 times)
Hi Guys
i am new to mining and need some help to debug my antminer s2 that i just bought
i bought two miners and one of them is working fine but other one don't show up on the network
if i connect to the computer directly then go thru the IPV4 and set according to the setup procedure then i can communicate with it
but as soon as i change the ip,sebnet,gateway settings to match my router and connect to router then i cannot ping it
i tried scanning IP addresses and it don't show there either.
things i tried
upgraded to the latest firmware (June 10)
i saved the configuration on the working miner and uploaded on this.
next thing i am planning to do is swap the working and non working miner's SD cards
please let me know if anyone has any suggestion
Thanks
i am new to mining and need some help to debug my antminer s2 that i just bought
i bought two miners and one of them is working fine but other one don't show up on the network
if i connect to the computer directly then go thru the IPV4 and set according to the setup procedure then i can communicate with it
but as soon as i change the ip,sebnet,gateway settings to match my router and connect to router then i cannot ping it
i tried scanning IP addresses and it don't show there either.
things i tried
upgraded to the latest firmware (June 10)
i saved the configuration on the working miner and uploaded on this.
next thing i am planning to do is swap the working and non working miner's SD cards
please let me know if anyone has any suggestion
Thanks
Jump to: