if it is under warranty and you are usa based they opened a center in los angles
you do not have to ship it to china.
Topic: Antminer s9 - dead board advice... (Read 903 times)
Did you ever fix your dead board? Same problem here bro please help me lol
Its not rocket science, just email them and get approval to send the defective unit off for repair.
Did you ever fix your dead board? Same problem here bro please help me lol
Yes you can run it with two boards. Get in contact with Bitmain to make a RMA case and remove the board and send it properly packed after they say ok.
Here are some instructions, useful to read https://enshop.bitmain.com/workOrderGuide.htm
Here are some instructions, useful to read https://enshop.bitmain.com/workOrderGuide.htm
I feared that might be the case - can you keep running on two boards though? Like a T9 ;-)
Time for warranty repair or fee based repair (Bitmain Warranty in Denver, Colorado).
Hi folks,
so I've got a dead board on one of my S9's. It was previously running well, but I had to move the machine. On reboot one board has no red light on the top (no power? but have double-checked connectors, and isn't hashing.
Asic status is only the mid-4, and chip temps are 0.
Any suggestions? Can I keep running with 2 boards, and if so is it best to disconnect the dead one from the PSU?
Many thanks in advance!
so I've got a dead board on one of my S9's. It was previously running well, but I had to move the machine. On reboot one board has no red light on the top (no power? but have double-checked connectors, and isn't hashing.
Asic status is only the mid-4, and chip temps are 0.
Any suggestions? Can I keep running with 2 boards, and if so is it best to disconnect the dead one from the PSU?
Many thanks in advance!
Jump to: