Thanks a lot for the clue. I will take a look at that. Would you have a suggestion to where to start looking?
anyway have a nice day!
Topic: Antminer S9 not working when using network switch ( network switch config? ) (Read 446 times)
November 01, 2017, 01:27:43 PM
Hi fanatic26,
Thanks a lot for the clue. I will take a look at that. Would you have a suggestion to where to start looking?
anyway have a nice day!
Thanks a lot for the clue. I will take a look at that. Would you have a suggestion to where to start looking?
anyway have a nice day!
November 01, 2017, 10:38:04 AM
Your switch is not just a dumb switch. It has access control lists, QoS management, and other things. You need to go through the settings of the switch and see whats going on.
November 01, 2017, 08:50:06 AM
i also wanna know about it
November 01, 2017, 08:39:12 AM
Hi there!
I have a few new antminserS9 ( september batch I believe ) and I am not able to connect to them ( of IP report ) when they are going through a netgear switch (prosafe GS752TPS) and then the router but they are working fine when connected directly to the router.
We also have an older S9 witch work perfectly when going through the switch and the router.
I did not do anything special for the older S9 in the switch of the S9 itself.
Is there some configuration in the S9 that could cause this issue? Or is it the switch?
Thanks for your help!
I have a few new antminserS9 ( september batch I believe ) and I am not able to connect to them ( of IP report ) when they are going through a netgear switch (prosafe GS752TPS) and then the router but they are working fine when connected directly to the router.
We also have an older S9 witch work perfectly when going through the switch and the router.
I did not do anything special for the older S9 in the switch of the S9 itself.
Is there some configuration in the S9 that could cause this issue? Or is it the switch?
Thanks for your help!
Jump to: