Antminers vs Avalon - Which start better in the cold?

fanatic26

hero member

Activity: 756

Merit: 560

Quote from: VentMine on November 28, 2017, 05:06:43 PM

Quote from: fanatic26 on November 28, 2017, 11:51:08 AM

Bitmains power supplies are just garbage. I have no cold start problems using higher end server PSUs. I have started my miners (s7, s9, e9, and Avalon 741s) around 0c before. They will not run at full speed until they warm up, but other than that you shouldnt have many problems if 5c is the lowest temp you will see.

Thanks fanatic26. Can you recommend a spec for "higher end server PSU's" and possibly where to buy them online? Preferably 1600W so they can run S9's.

The Delta 2400w units the parallelminer sells are brand new high quality units. I have tested them personally over 92% efficiency. Right now those would be my suggestions for S9 power supplies.

tranthanhhamnkhuy

newbie

Activity: 2

Merit: 0

)))

VentMine

full member

Activity: 236

Merit: 105

Quote from: fanatic26 on November 28, 2017, 11:51:08 AM

Bitmains power supplies are just garbage. I have no cold start problems using higher end server PSUs. I have started my miners (s7, s9, e9, and Avalon 741s) around 0c before. They will not run at full speed until they warm up, but other than that you shouldnt have many problems if 5c is the lowest temp you will see.

Thanks fanatic26. Can you recommend a spec for "higher end server PSU's" and possibly where to buy them online? Preferably 1600W so they can run S9's.

fanatic26

hero member

Activity: 756

Merit: 560

Bitmains power supplies are just garbage. I have no cold start problems using higher end server PSUs. I have started my miners (s7, s9, e9, and Avalon 741s) around 0c before. They will not run at full speed until they warm up, but other than that you shouldnt have many problems if 5c is the lowest temp you will see.

Steamtyme

legendary

Activity: 1568

Merit: 2037

I have started my 741's in 5C and they were just fine. What I did notice is that when I did this I did get error codes 512 and 16 on a couple of the EC readouts in the API log. They did not affect anything, and the next time I restarted them they were gone. That was after the miners had heated my garage a little.

What are the scenarios for your miners shutting down? Is it possible to have a space heater or something that comes on when they are offline to keep up a temperature?

jijikill

full member

Activity: 168

Merit: 100

I think antminer is definitely better in terms of efficiency , pricing and electricity savings

VentMine

full member

Activity: 236

Merit: 105

I have a bunch of Antminer S9's and I notice they do not start up when cold. Like even 5 degC can be too cold. From what I observed, when I heat the PSU (AP3W++) first, it starts fine. So it seems it's more so a PSU problem than Antminer problem.

Curious - How do the Avalons start in the cold?

Should I be looking at different PSU's for my Antminers than the APW3++?

My application is a remote mine, it shuts down temporarily once in a while, so I need a way to start the miners reliably.

Topic: Antminers vs Avalon - Which start better in the cold? (Read 441 times)