AntRouter R1-LTC Wireless Bridge - Sharing Wifi to LAN port?

Pyrojason

copper member

Activity: 174

Merit: 10

Quote from: sarcheer on September 27, 2018, 07:52:42 AM

https://wiki.openwrt.org/doc/recipes/relayclient

This is what I used to allow my R1-LTC to share wifi through its LAN port to connect one of my R4's to the internet. Still mines and is fully functional otherwise. Just make sure you customize the settings to your network.

Good luck!

Using the built-in R1-LTC GUI, how would you achieve this? The relayclient instructions are a bit different to follow as I've never attempted this before. Do you have any information on how to use the built-in GUI to do the same thing? It sounds like you got it to work a while back.

Pyrojason

copper member

Activity: 174

Merit: 10

This is for the same topic which wasn't answered directly on this page. I know it's an old post. I know it's possible.
How do you configure the R1 to grab a Wi-fi signal and share it through the Ethernet port for providing a device with no built-in wireless a connection to the internet? I have it configured to mine online successfully. When I try to 'bridge' the wireless and lan connection it restarts and the wifi light goes dark with no more communication until I do a hard reset. (Backup of settings prior to experimenting with settings is a time saver for reloading it after the inevitable failure.) Sharing on other devices has been far simpler than with this one but I'm sure it's just a setting missing.

BitMaxz

legendary

Activity: 3374

Merit: 3095

Playbet.io - Crypto Casino and Sportsbook

You mean you want to make your AntRouter R1-LTC as a repeater to expand your wifi signal in your house?
Or are you talking about connecting your R1-LTC to wifi without a cable? I found a youtube guide where you can connect it without using ethernet cable just follow the guide from here https://www.youtube.com/watch?v=tat5o9uZHMI

sarcheer

copper member

Activity: 330

Merit: 103

https://wiki.openwrt.org/doc/recipes/relayclient

This is what I used to allow my R1-LTC to share wifi through its LAN port to connect one of my R4's to the internet. Still mines and is fully functional otherwise. Just make sure you customize the settings to your network.

Good luck!

FOMO Arigato

newbie

Activity: 1

Merit: 0

I'd like to get some use out of an old AntRouter I have laying around. I figured since it can connect to the house's WiFi signal and has a LAN port, I should be able to use it as a WiFi bridge - sharing the connection it's picking up out of it's LAN port.

Trying to use it that way rather than having to run a 100' Ethernet cable from my roommate's room to the router, or have to buy a wireless card to add to her desktop.

Has anyone had any success using this device as a WiFi bridge? Exhaustive search didn't find anything - the only reference I can find to this anywhere was in the R1-LTC manual which directs you to change protocol to PPPoE which is only applicable to DSL connections, and I'm using a cable modem.

Hours fiddling with the AntRouter settings and can't seem to get it to assign an IP, any help on how to do this in the settings (or flash over it since it's not at all worthwhile as a miner anymore) would be greatly appreciated. Thanks : )

Topic: AntRouter R1-LTC Wireless Bridge - Sharing Wifi to LAN port? (Read 164 times)