Since you disconnected the m.2 recently then there is a possibility that you inserted the m.2 drive incorrectly.
You can try these steps:
- unplug the m.2 drive again and insert it back to the unit.
- If it didn't work unplug it again and check the terminals and maybe there are some dirt and rust clean it using a pencil eraser or isopropyl alcohol then replug it again and test.
Topic: Apollo BTC beginner (Read 105 times)
hello
today i install my apollo full node and a standard apollo
On first launch everything worked fine and I can log into the dashboard...then I updated the dashboard to 0.3.4
then i clicked through the dashboard and saw that the node was not started. I tried to start it and waited 5-15 minutes.. nothing happened..
then i wanted to check the m.2 card and shut down the apollo in the dashboard.. m.2 was ok...so everything was switched on again...since then it can no longer be found in the network...red led lights up and fan is off
I then connected an HDMI monitor and a mouse but the monitor gets no signal
is there a power button somewhere?
what are those mini buttons on the board?
thanks for any help
today i install my apollo full node and a standard apollo
On first launch everything worked fine and I can log into the dashboard...then I updated the dashboard to 0.3.4
then i clicked through the dashboard and saw that the node was not started. I tried to start it and waited 5-15 minutes.. nothing happened..
then i wanted to check the m.2 card and shut down the apollo in the dashboard.. m.2 was ok...so everything was switched on again...since then it can no longer be found in the network...red led lights up and fan is off
I then connected an HDMI monitor and a mouse but the monitor gets no signal
is there a power button somewhere?
what are those mini buttons on the board?
thanks for any help
Jump to: