Topic: ASIC Cube Bloc Erupter problem (Read 748 times)
it was my network cable. I switched the cable between my blade that was working and this one, and now it works. Need to get a new cable, thanks for your reply !
It's seems to be a stratum capacity problem, i had same issue whit the Raspberry Pi until i install stratum proxy to windows desktop. Lot of zero's on block web pages means chips do not get any work to calculate...
Hi,
I just ordered an ASIC Cube Bloc Erupter and I was wondering if anyone had this problem before. I can't get it higher than 1,5 GH/s, it is supposed to do 30-38 Gh/s. I have the same problem in low clock and high clock. The PSU used is Thermaltake 850W, tried other PSUs with the same problem. I have a Block erupter blade using the same proxy that is able to hash successfuly at 10 Gh/s so I don't think it's a stratum proxy problem either. Unit does not appear to reboot according to the up time in the web interface. Any other clues ?
Status light is flashing red.
Here is a prinscreen of my cube web interface :
http://pages.infinit.net/smashp/Untitled.gif
Thanks
I just ordered an ASIC Cube Bloc Erupter and I was wondering if anyone had this problem before. I can't get it higher than 1,5 GH/s, it is supposed to do 30-38 Gh/s. I have the same problem in low clock and high clock. The PSU used is Thermaltake 850W, tried other PSUs with the same problem. I have a Block erupter blade using the same proxy that is able to hash successfuly at 10 Gh/s so I don't think it's a stratum proxy problem either. Unit does not appear to reboot according to the up time in the web interface. Any other clues ?
Status light is flashing red.
Here is a prinscreen of my cube web interface :
http://pages.infinit.net/smashp/Untitled.gif
Thanks
Jump to: