Topic: asic v2 blade help with power (Read 514 times)
Not sure what you mean
Certainly but you should try the "services" section about this problem.
So long story short. I tried to follow the guide here and seem to be abke to get it to partially power up.
I have tried multiple new power power supplies. Frimm 350w up to 650w. Various different models and manufacturers.
I made the molex adapter. I have both 12v + going to one spot and 2 of the negative (black) going to each of y he negative terminals. With this setup only in a old power supply can I get mostly o's 3/4 of the way through it shows 4 x's then a few more o's.
However no matter what I do. I can nit use any other power supply. Including 3 brand new power supplies. A 450w, 500w, and a 650w.
I have tried hooking this up with nothing but the blade and still the same result. Then the blade and 3 crappy 80mm case fans. Same result.
I'm not sure what I am not doing right but I've been working on this fir almost 4 days and can not seem to find any real clear pictures of what it should look like.
Any help and or pictures would be greatly appreciated.
Thanks,
Nathan
I have tried multiple new power power supplies. Frimm 350w up to 650w. Various different models and manufacturers.
I made the molex adapter. I have both 12v + going to one spot and 2 of the negative (black) going to each of y he negative terminals. With this setup only in a old power supply can I get mostly o's 3/4 of the way through it shows 4 x's then a few more o's.
However no matter what I do. I can nit use any other power supply. Including 3 brand new power supplies. A 450w, 500w, and a 650w.
I have tried hooking this up with nothing but the blade and still the same result. Then the blade and 3 crappy 80mm case fans. Same result.
I'm not sure what I am not doing right but I've been working on this fir almost 4 days and can not seem to find any real clear pictures of what it should look like.
Any help and or pictures would be greatly appreciated.
Thanks,
Nathan
Jump to: