Topic: ASICMiner Blade - technical problem with mobile phone (Read 1465 times)
Seen it before, no (easy) fix.
Any other ideas ?
-----------------------------------
Maybe you can start disabling QoS -> without changes
set mac-adress where is runing mining-proxy to high prioryty -> without changes
I can not set LG phone to low priority QoS because I not know the mac address, ipscan doesnt show it.
-----------------------------------
-----------------------------------
Maybe you can start disabling QoS -> without changes
set mac-adress where is runing mining-proxy to high prioryty -> without changes
I can not set LG phone to low priority QoS because I not know the mac address, ipscan doesnt show it.
-----------------------------------
Maybe your router have QoS features and give a high % of bandwidth to your phone conections, blades use getwork protocol and need more bandwidth, are you using a stratum proxy in your lan? or are you connecting blades with getwork to pools?
Regards
Regards
mining_proxy.exe -o mint.bitminter.com -sp 3333 -gp 8332
and my router is
Linksys E4200
Maybe you can start disabling QoS, I read some theads about issues with QoS in this router
Maybe your router have QoS features and give a high % of bandwidth to your phone conections, blades use getwork protocol and need more bandwidth, are you using a stratum proxy in your lan? or are you connecting blades with getwork to pools?
Regards
Regards
mining_proxy.exe -o mint.bitminter.com -sp 3333 -gp 8332
and my router is
Linksys E4200
Maybe your router have QoS features and give a high % of bandwidth to your phone conections, blades use getwork protocol and need more bandwidth, are you using a stratum proxy in your lan? or are you connecting blades with getwork to pools?
Regards
Regards
Hello,
I would like to share one technical problem with you.
I bought new asicminer blades and i connected they with old asicminer blades through the switch to my network.
In this network i have one wifi router on the first floor and the second in the celler. The one in the celler is also a DPCP server and also my gate to the internet.
My blades are working fully to the point when I connect the new android LG phone through one of my wifi into my network.
All the IP adresses are correct and there is no conflict anywhere, however my blades´ computational power decrease to 40-50%.
When I disconnect the phone from the wifi everything works again perfectly.
Ive already update the android sw but it did not help. I do not understand and cannot solve this problem.
I would like to share one technical problem with you.
I bought new asicminer blades and i connected they with old asicminer blades through the switch to my network.
In this network i have one wifi router on the first floor and the second in the celler. The one in the celler is also a DPCP server and also my gate to the internet.
My blades are working fully to the point when I connect the new android LG phone through one of my wifi into my network.
All the IP adresses are correct and there is no conflict anywhere, however my blades´ computational power decrease to 40-50%.
When I disconnect the phone from the wifi everything works again perfectly.
Ive already update the android sw but it did not help. I do not understand and cannot solve this problem.
Jump to: