This frustrated the living shit out of me also. I finally got it to work by making sure I set it up for TWO servers (i was trying to change it for one server)
Ports:8332,8332
Server addresses: 192.168.1.5,192.168.1.5
user:pass: user:password,user:password
Of course, they are one and the same server, but I don't think it matters.
Topic: ASICMiner Block Erupter Blade won't configure (Read 587 times)
Ok so I got a new 11GH blade (AM BE REV 2.01 is what it says on the back) I was able to hook it up to a power supply fairly easily but after connecting to the configuration page at http://192.168.1.254:8000/ I have ran into problems. All of the field will update and save correctly EXCEPT the server address and username/password. Whenever I try and hit update/resart it ends up with "pdate/Restart,update=Update/Restart" in the username password field. I was able to contact the seller they had seen this problem and gave me this advice.
"We have seen something similar before. Can you try the following:
Enter your desired configuration settings.
Click update and wait.
Wait for blade to restart and the LEDs on the blade to finish flashing.
Open a new tab/window to the configuration page.
After that, the settings should have stuck
"
Unfortunately that did not seem to fix it for me and after trying EVERY possibly combination I can think of to input the server data and submit it to the blade I have still been unsuccessful.
Has anyone else seen this problem before? How did you resolve it and or if anyone could think of a possible work around. Fairy frustrated here any help would be much appreciated.
"We have seen something similar before. Can you try the following:
Enter your desired configuration settings.
Click update and wait.
Wait for blade to restart and the LEDs on the blade to finish flashing.
Open a new tab/window to the configuration page.
After that, the settings should have stuck
"
Unfortunately that did not seem to fix it for me and after trying EVERY possibly combination I can think of to input the server data and submit it to the blade I have still been unsuccessful.
Has anyone else seen this problem before? How did you resolve it and or if anyone could think of a possible work around. Fairy frustrated here any help would be much appreciated.
Jump to: