Author

Topic: AX1200i dies immediately after starting up - KNC Titan (Read 459 times)

sr. member
Activity: 407
Merit: 255
Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?

I used a AX1200i once to try and power a Titan cube. Caused the same issue. The Corsair AX1200i has a power throttle on rails to protect from over current.
copper member
Activity: 2898
Merit: 1465
Clueless!


Sent you a PM ..If I can't figure it out I will refer you to bigger guns that can do more

later

brad
newbie
Activity: 3
Merit: 0
Thanks! I will message him.
legendary
Activity: 4256
Merit: 8551
'The right to privacy matters'
Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?

searing   should know

his profile

https://bitcointalksearch.org/user/searing-99165
newbie
Activity: 3
Merit: 0
Hello,

I just bought an AX1200i and an AX760i to power a KNC Titan. After connecting everything up, I hit the power and both PSUs shut off almost immediately with a clicking noise. I've seen lots of similar reports, but I can't find a solution. I've got the 24pin jumped correctly, all connections are tight, and I am using the KNC supplied Y cables.

Does anyone know how to get these supplies to run with a Titan?
Jump to: