D'oh! Thanks!
I get Homer moments quite often,I'm starting to enjoy them
Yes, they are quite enjoyable!
Topic: BAMT with a Gigabyte 990fxa-UD3 not Booting (Read 1719 times)
I get Homer moments quite often,I'm starting to enjoy them
Yes, they are quite enjoyable!
D'oh! Thanks!
I get Homer moments quite often,I'm starting to enjoy them
There are only 2 ways to get BAMT to boot on that crap mobo. (I have it as well) 
Put the BAMT image on a hard drive and boot that (easy way)
Boot plop on one small usb stick or cd then chain load BAMT from a second usb stick. (you may have to remove the plop usb stick first)
I don't think anyone has managed to get it down to 1 usb stick that contains plop and BAMT. (I never could)
Put the BAMT image on a hard drive and boot that (easy way)
Boot plop on one small usb stick or cd then chain load BAMT from a second usb stick. (you may have to remove the plop usb stick first)
I don't think anyone has managed to get it down to 1 usb stick that contains plop and BAMT. (I never could)
D'oh! Thanks!
Did you go into your BIOS & set the device as First Boot Device 
Instead of HHD or CD ROM............
Instead of HHD or CD ROM............
Okay, I'm going insane trying to figure this out.... I have a Gigabyte 990fxa-UD3 motherboard and I'm trying to run BAMT without a HDD. So I did what was recommended on this forum post and used unetbootin to flash a USB drive with plopKexec, but when I boot it up, it says "Missing operating system" over and over and over.
If I unplug the USB while the message is flashing, it then says "DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER".
Can anyone please help?
Thanks
If I unplug the USB while the message is flashing, it then says "DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER".
Can anyone please help?
Thanks
Jump to: