S3 IP is 192.168.1.99
If your LAN is different, you have to setup your S3 first.
Plug your computer directly to the S3.
Change your computer IP for 192.168.1.10, for example.
Go to the S3 interface using http://192.168.1.99 et change WAN setup from static address to DHCP client (network > wan > edit > protocol), apply changes, then replug to your router (and restore your computer IP).
(sorry if bad english, I'm french)
Topic: Bitmain Antminer S3+: No IP only ethernet is on and blinking every 50 seconds. (Read 2662 times)
October 19, 2014, 03:08:23 PM
October 18, 2014, 07:34:50 PM
Good Day all,
I purchased my first Bitmain Antminer S3+ from ebay and I use is since 2 weeks ago. It works perfectly, however, this Thursday night Verizon mistakenly cut off my FIOS and the Bitmain began to open its tone error sound indicator. So I close the PSU (850W) then at Friday evening or yesterday, Verizon re-connected my FIOS.
Unfortunately, after I connected it properly and waited for 45~50 seconds the red LED powers solidly then after the Ethernet indicator (both green and orange) turned off, the red LED turns off it self then the Ethernet indicator turned on and every after 50 seconds it blinks.
I checked my Verizon router admin page and I cannot see the IP address for my Bitmain...
I cannot access the my Bitmain page for configuration re-adjustment. I restarted the miner but still no good its the same issue.
I really need help or information to tackle this issue and I hope my miner is not broken :(
For further details please see attached pic...
http://s26.postimg.org/evpje71hx/20141018_201723.jpg
I purchased my first Bitmain Antminer S3+ from ebay and I use is since 2 weeks ago. It works perfectly, however, this Thursday night Verizon mistakenly cut off my FIOS and the Bitmain began to open its tone error sound indicator. So I close the PSU (850W) then at Friday evening or yesterday, Verizon re-connected my FIOS.
Unfortunately, after I connected it properly and waited for 45~50 seconds the red LED powers solidly then after the Ethernet indicator (both green and orange) turned off, the red LED turns off it self then the Ethernet indicator turned on and every after 50 seconds it blinks.
I checked my Verizon router admin page and I cannot see the IP address for my Bitmain...
I cannot access the my Bitmain page for configuration re-adjustment. I restarted the miner but still no good its the same issue.
I really need help or information to tackle this issue and I hope my miner is not broken :(
For further details please see attached pic...
http://s26.postimg.org/evpje71hx/20141018_201723.jpg
Jump to: