Hello all
- I was looking into mining Bitsend on GPU's
I have tried it on Suprnova and it's finally confirmed my transaction.
Here is the problem I am running into now!
My test system has 1 1080 rig in and works getting stock settings 3684kH/s
but when I move it over to my 4 card system 1080's it starts out ok at about 3000kH/s but then drop down to 15mH/s per card.
Using the exact same bat file
ccminer -a xevan -o stratum+tcp://bsd.suprnova.cc:8686 -u DLLAMKE70.PC1080 -p x
What is happening here and Why
Any help would be much appreciated
Thanks
-
- I was looking into mining Bitsend on GPU's
I have tried it on Suprnova and it's finally confirmed my transaction.
Here is the problem I am running into now!
My test system has 1 1080 rig in and works getting stock settings 3684kH/s
but when I move it over to my 4 card system 1080's it starts out ok at about 3000kH/s but then drop down to 15mH/s per card.
Using the exact same bat file
ccminer -a xevan -o stratum+tcp://bsd.suprnova.cc:8686 -u DLLAMKE70.PC1080 -p x
What is happening here and Why
Any help would be much appreciated
Thanks
-
chances are its not your rig but the mh/s coming into the pool. did you check to see what difficulty comes up with one card then check what difficulty the pool throws at you when coming in with 4 cards? That will make a difference to your mh/s . you can try adjusting it although im not sure if you can with that pool or algo but its work a try .
instead of -p x try -p d=6 or whatever you like try experimenting you should get some crazy results but if it works . just dont go to low or to high
ok i tryed it and d= wont work but you can try -m 40 or experiment with that number mayby -m 200 .
