Author

Topic: Blade Eruptor shut down (Read 1750 times)

member
Activity: 97
Merit: 10
October 25, 2013, 09:28:56 AM
#10
it has been working fine since, it was a loose power connecter

Be careful about NOT over-tightening the screws in the green power connector for your asicminer blades --it is more of a spring action system as opposed to a true screw bearing down on a bare copper wire.

I got seven blades running in a bath of mineral oil that is circulated thru a small automotive transmission oil cooler that I places in my bathroom's sink that is constantly running cold water (water is free in my condo.)
hero member
Activity: 1246
Merit: 501
October 10, 2013, 06:55:35 AM
#9
try to reset blade.

try to read thread.

 Roll Eyes
sr. member
Activity: 280
Merit: 250
October 10, 2013, 06:36:46 AM
#8
try to reset blade.
sr. member
Activity: 266
Merit: 250
legendary
Activity: 1148
Merit: 1000
October 08, 2013, 07:28:16 PM
#6
it has been working fine since, it was a loose power connecter
hero member
Activity: 1246
Merit: 501
October 08, 2013, 10:14:15 AM
#5
full member
Activity: 196
Merit: 100
October 08, 2013, 10:01:53 AM
#4
There may be hardware fault ?
legendary
Activity: 1148
Merit: 1000
October 01, 2013, 12:08:25 PM
#3
i think i narrowed it down

the power cable is loose

the internet is fine the raspberry pi and my other rigs are on the same router and all connected

once i touched the green plug the light started blinking

sr. member
Activity: 336
Merit: 250
October 01, 2013, 07:48:18 AM
#2
How is your internet connection? A year ago I had a modem/router that would need to be restarted maybe twice a day. It was an absolute pain in the ass, and couldn't figure out why it did it (eventually got a new one after screwing about with DD-WRT's auto reboot settings for a week).
legendary
Activity: 1148
Merit: 1000
October 01, 2013, 06:40:04 AM
#1
Hello

I woke up this morning and bfgminer was alerting that the blade eruptor is dead

and i tried to access it but it wasn't accessible from the ip address conf page, so i shut down the psu and turn it back on and it came back

any reason why it did that?

i am using 600 watt power supply and nothing is connected to it but the blade

i purchased the blade 2 weeks ago

Thanks
Jump to: