Topic: BTCPay Server and missing transactions. Help! (Read 184 times)

Actually, if you follow their guide carefully on how to make a wallet for BTCpayserver you will not experience this issue because they added this if how much gap limit you need to put. If you have a big merchant shop you need to increase the gap 500 above.

Look at this how they make an Electrum wallet for BTCserver: Electrum Wallet Setup for BTCpayserver

I suggest you read their docs carefully so that you won't experience any issues.

Thanks very much. Turns out that gap limit was the issue. Found these as well, a bit more in depth what gap limit is:
https://docs.btcpayserver.org/faq-and-common-issues/faq-wallet#missing-payments-in-my-software-or-hardware-wallet
https://blog.blockonomics.co/bitcoin-what-is-this-gap-limit-4f098e52d7e1

IIRC electrum only shows the 1st 20 addresses by default.
This may or may not be correct but take a look at:

https://www.reddit.com/r/Electrum/comments/a87l42/electrum_how_to_generate_many_recipient_addresses/


Not 100% sure if this is your issue but since it stopped at 20 for you it seems likely.

-Dave

As long as you have downloaded the official open source software and not through some other resource then all the code is transparent and accessible by anyone so it would be unlikely that the software is compromised. However this does not prevent your specific website/code from being compromised. I'm assuming that to change anything relating to the deposit address admin privileges would be needed. Check whether there has been any unauthorized access and any changes to the code. If this is not the case then there must be a mistake in configuration and without seeing your specific configuration it would be difficult to find a cause.

Where did you download the software from?

Hi there,

I am using electrum wallet and I'm using BTCPayServer to receive payments / pay button to generate invoices.

All was working fine for about 20 transactions, I could see transactions coming in just fine. Past couple days, however, I can see transactions going through in BTCPayServer but I don't see these transactions in my Electrum wallet anymore. I even switched networks to make sure wallet is syncing properly but no luck. I am a newbie with BTC and BTCPayServer and don't know where to start looking.

I can definitely see the transactions made it to blockchain and have some confirmations, eg.
https://blockstream.info/tx/599e1290a9577c831537ff8d2739da5e98dbf9866abc279f2236045b14a8a46d

I also see the deposit addresses but I can't tell if payment would go to my wallet or not. BTCPayServer Pay Button uses my wallet public key to generate an invoice every time someone clicks Pay. The deposit address should be mine and, as I mentioned, was working for about 20 transactions but I am no longer seeing any transactions in Electrum wallet.

With my rusty knowledge of crypto I have a few guesses:
1) BTCPayServer store has some issue where the deposit address is sending funds elsewhere and not my wallet.
2) Electrum wallet is not syncing properly so I can't see the funds that are actually mine.

As I continue investigating I'm thinking (1) is more likely. Public key in store seems fine and has not been tampered with. I would like to somehow validate that deposit address is actually going to my wallet or not. I can wait to see if they eventually sync but with many confirmations I assume they should already appear in my wallet.

If someone know what the problem could be please let me know. I know I can set up a new store and try a different wallet but the same thing might happen again. It would be great if I can understand what is going on.

Thank you so much!
Tim