Author

Topic: Can I flash a Avalon Batch 2 through USB? (Read 788 times)

legendary
Activity: 1112
Merit: 1000
December 22, 2013, 11:53:16 AM
#2
I just picked up an Avalon Batch 2 with a faulty NIC. Is there any way to flash the firmware? I'd like to OC it.

I've ran a few searches without any luck.

depending on how it's set up (you can do a factory reset), you can connect over wifi. This will allow you do do the configuration and connect it over wifi to the internet.

If the TP-LINK board is defective, you can either replace it or run the USB cable direct to another host running cgminer (look at it's thread for details) thus using the 3 modules at 85+ GH/s
newbie
Activity: 16
Merit: 0
December 21, 2013, 11:00:29 PM
#1
I just picked up an Avalon Batch 2 with a faulty NIC. Is there any way to flash the firmware? I'd like to OC it.

I've ran a few searches without any luck.
Jump to: