Topic: Can you help with cgminer (Read 684 times)
Many thanks for helping
Make sure your powered hub is not a usb3 hub as most don't work with an RPi. Unplug the hub and the devices and start cgminer. Then plug in the hub and plug in one device at a time. The *fury usb sticks and the block erupters sometimes don't like starting together for reasons that aren't entirely clear.
Hi to all just need a little help I have finally got cgminer installed on my raspberry pi but when I come to run it it's returning a message "No devices detected" .
I just can't get around the problem I have been looking for hours on the Internet but can't seem to get a straightforward answer to this problem I imagine it's something straight forward but they seems to be known straight forward answer one thing for sure if someone was to make a sd card with all the settings ready to go in the raspberry pi they probably would make a killing on ebay I for one would buy that. What am I doing wrong can you help please.
I have two erupters one is a redfury 2.6gh and the other is some general 333 erupter I am using a powered usb hub D-link so as far as I can say ther should be no problems.
If you can help keep it simple as I am not that technically minded
Many thanks if you can help.
I just can't get around the problem I have been looking for hours on the Internet but can't seem to get a straightforward answer to this problem I imagine it's something straight forward but they seems to be known straight forward answer one thing for sure if someone was to make a sd card with all the settings ready to go in the raspberry pi they probably would make a killing on ebay I for one would buy that. What am I doing wrong can you help please.
I have two erupters one is a redfury 2.6gh and the other is some general 333 erupter I am using a powered usb hub D-link so as far as I can say ther should be no problems.
If you can help keep it simple as I am not that technically minded
Many thanks if you can help.
Jump to: