The OP mentions that he is trying to run the Compac F - you need the latest cgminer build from Kano to run them because -vh's versions do not have the ASIC chip driver needed and of course -ck's outdated versions do not either. https://github.com/kanoi/cgminer
Home thread for the Compac Ferrari is https://bitcointalksearch.org/topic/m.57735149 that is also where you find the installation instructions. Use the link in the opening post there to jump to the install instructions and suggested running commands.
Topic: cgminer command line for 3 Workers (Read 190 times)
Maybe you will need to overclock them I check the cgminer command you can adjust the frequency of this USB stick. Read the command line below
Or if not then try to seek help from this official thread below don't forget to read the first page there are some commands that I think you can try.
- https://bitcointalksearch.org/topic/gekkoscience-compac-bm1384-stickminer-official-support-thread-1173963
Also read all commands here http://ck.kolivas.org/apps/cgminer/
Code:
--compac-freq Set GekkoScience Compac frequency in MHz, range 100-500 (default: 150.0)
Or if not then try to seek help from this official thread below don't forget to read the first page there are some commands that I think you can try.
- https://bitcointalksearch.org/topic/gekkoscience-compac-bm1384-stickminer-official-support-thread-1173963
Also read all commands here http://ck.kolivas.org/apps/cgminer/
To start my bitcoin mining experience I have purchased the bitcoin merchant 3x Gekko Compac F combo with Raspberry Pi 4 preinstalled with cgminer. I want to set each mining stick as a different worker on slushpool. I enter the following terminal commands:
cd git/vthoang/cgminer
sudo ./cgminer -o stratum+tcp://us-east.stratum.slushpool.com:3333 u myacctname.palermo1
Terminal responds showing 3 chips ramping up to 200-300 h/s each
Switching to slushpool shows one Worker named palermo1, status OK ramping up to 302.8 GH/s scoring hashrate.
This appears to be only one chip working??? All three sticks are blinking and working minimal heat. How do I change my code to get three workers running around 300 GH/s each?
Help appreciated as I am having difficulty learning to do this.
Cas1m1r
cd git/vthoang/cgminer
sudo ./cgminer -o stratum+tcp://us-east.stratum.slushpool.com:3333 u myacctname.palermo1
Terminal responds showing 3 chips ramping up to 200-300 h/s each
Switching to slushpool shows one Worker named palermo1, status OK ramping up to 302.8 GH/s scoring hashrate.
This appears to be only one chip working??? All three sticks are blinking and working minimal heat. How do I change my code to get three workers running around 300 GH/s each?
Help appreciated as I am having difficulty learning to do this.
Cas1m1r
Jump to: