Topic: Coinjoining on Sparrow 1.8.5 (Read 160 times)

nc50lc

legendary

Activity: 2618

Merit: 6452

Self-proclaimed Genius

Quote from: Revolter on April 16, 2024, 09:39:32 AM

Should I expect it to say "Registered input" like on 1.7.x rather than "Register input"?
-snip-
(Edited) I just looked now at Sparrow again and I have had some remixes since I made this post. So it seems that this is normal.

I can confirm this as I happen to have an existing postmix UTXO in TestNet and that specific UTXO displays it differently in old and new versions.

Here's some screenshots for comparison:

Old Version (output ...56d...:2)
Close wallet, then open in version 1.8.5:

Latest Version (same output ...56d...:2)

Revolter

newbie

Activity: 5

Merit: 18

I just have upgraded Sparrow from 1.7.x to 1.8.5. With 1.7.x when I was waiting for remixes, hovering over the bar for each output would say "Registered input (1 of xxx)" while you were waiting for a remix. With 1.8.5 the bar for each output does not fill as far when waiting, and now it says "Register input (20%) when hovered.

Is this normal? I know 1.8.5 has updated to use Soroban so wanted to check this is normal and not something gone wrong on my end? Should I expect it to say "Registered input" like on 1.7.x rather than "Register input"?

(Edited) I just looked now at Sparrow again and I have had some remixes since I made this post. So it seems that this is normal.

Bitcoin Forum>Bitcoin>Development & Technical Discussion>Wallet software

Jump to: