Author

Topic: Configuring MultiMiner to read your V2 blades ? (Read 2392 times)

hero member
Activity: 840
Merit: 1002
December 07, 2013, 11:32:14 PM
#4
Nwools you are amazing good sir. I am working on a speedometer style gauge to display hashing power graphically like bitminter does. Anything i need to know about the code before i dive in to it?

Not really. I think placing it under the existing View menu would make sense visually. And then just hide the main ListView and display your UI. Let me know if you have any questions. There's historical data stored in JSON in %appdata%\MultiMiner.
full member
Activity: 140
Merit: 100
Nwools you are amazing good sir. I am working on a speedometer style gauge to display hashing power graphically like bitminter does. Anything i need to know about the code before i dive in to it?
hero member
Activity: 840
Merit: 1002
Just wondering if anyone had any info on if it was possible, and if so how it is done, to configure the new MultiMiner software to recognize your V2 ASICminer blades. IE; if you had 10 of them mounted on a backplane.

In MultiMiner go into Settings > Advanced miner setting and enable the Stratum Proxy. Point your Blades at the IP address of your MultiMiner PC and the Getwork port configured in the settings dialog. Thats about it.
full member
Activity: 140
Merit: 100
Just wondering if anyone had any info on if it was possible, and if so how it is done, to configure the new MultiMiner software to recognize your V2 ASICminer blades. IE; if you had 10 of them mounted on a backplane.

Thanks in advance  Wink
Jump to: