Author

Topic: DragonMint T1, Innosilicon T1, Aladdin t1 dead after update firmware (Read 243 times)

legendary
Activity: 3374
Merit: 3095
Playbet.io - Crypto Casino and Sportsbook
How to solder sd card to t1 control board. Did you do that?

If the control board does not have an SD card slot then you can try to solder an SD card connector it looks like this below



Just resolder them with 30watts soldering iron and soldering lead.
Or if you don't want to spend you can directly jumper the terminals using magnetic or any wire just make sure there is no short.
newbie
Activity: 4
Merit: 0
How to solder sd card to t1 control board. Did you do that?
legendary
Activity: 3374
Merit: 3095
Playbet.io - Crypto Casino and Sportsbook
Good evening, nice to greet you. I have an Aladdin T1 42th. I would like to know if this machine has any updated firmware.


Next time use Google Translate before you post here this is not a local section.

Try the firmware from Braiins OS I think it supports Aladdin t1.

Can you access the miner through a browser to check the HW version because g19 units can be still able to flash through an SD card?

Anyway, try this firmware that was already posted here on the forum before

- http://ck.kolivas.org/temp/

or from this post

- https://bitcointalksearch.org/topic/m.56689163
newbie
Activity: 1
Merit: 0
Buenas noches gusto en saludarte yo tengo una Aladdin T1 42th quisiera saber si está máquina tiene algún firmware de actualización .

legendary
Activity: 3374
Merit: 3095
Playbet.io - Crypto Casino and Sportsbook
Why not you can try to solder SD card and it through sd card. Thats the only option to revive this unit.

You can find the SD card firmware here https://www.innosilicon.com/html/support_en/download.html
Check it under a4+ then look for g19 tf card boot image.

If success then flash it back to the original firmware which is t1.
newbie
Activity: 2
Merit: 0
I have one of these rare machines with 4 hash plates, the problem came when one of these went away, the firmware of my machine does not have an event log, so I tried to update the software to an original one. The control board is the G19 model without sd reader, after updating the control board it has died, it only turns on a small red led marked on the board as D1, if you press the reset button it turns off and a led turns on green D10 and the fans go up to 100% but in no case do the front lights or the network card turn on. I have tried pressing the ip button, both at the same time and the reset button for several minutes, but it does nothing new. I don't know how to install a new firmware, the board has several pins, a row called J25 and another called J26, maybe by bridging one of them the firmware will be reset, I have also thought about soldering an sd reader, I don't know if any of them have any idea of ​​how I can recover the plate, I need help, thanks

https://telegra.ph/file/48951f64e2f7a4a4734e4.jpg
Jump to: