Bitcoin Forum>Bitcoin>Development & Technical Discussion>Wallet software>Electrum
Author

Topic: Electrum command lines (Read 1587 times)

btcven
hero member
Activity: 715
Merit: 500
Bitcoin Venezuela
Electrum command lines
March 13, 2013, 05:05:58 PM
#4
Quote from: taiping on March 13, 2013, 07:45:22 AM
Thank you. I have now downloaded the Windows Installer version.
Perhaps the documentation could make clear the commands are not applicable to windows.

Commands used to be available in previous versions. They are planned to be added somewhen in future versions again.
taiping
newbie
Activity: 28
Merit: 0
Re: Electrum command lines
March 13, 2013, 07:45:22 AM
#3
Thank you. I have now downloaded the Windows Installer version.
Perhaps the documentation could make clear the commands are not applicable to windows.
btcven
hero member
Activity: 715
Merit: 500
Bitcoin Venezuela
Re: Electrum command lines
March 12, 2013, 01:23:02 PM
#2
You can download the Electrum Installer or the Electrum Standalond for Windows from http://electrum.org

In Windows you cannot use commands, it is not officially supported yet. Also to be able to use commands (Linux and Mac) you'll need to install the dependencies before.
taiping
newbie
Activity: 28
Merit: 0
Re: Electrum command lines
March 12, 2013, 02:46:53 AM
#1
As a Newbie I downloaded ELECTRUM.
At https://en.bitcoin.it/wiki/Electrum#Export_and_import_addresses I have to put the "addresses" command $ ./electrum addresses -ak
Does this refer to the Command Prompt in Windows 7 ?
If I put this command into the Command Prompt and press Enter it says "$" is not recognised as a command prompt.
So I then put ./electrum addresses -ak (without the "$") I get the same thing. Same thing with electrum addresses -ak

Also, am I correct in thinking that ELECTRUM is not installed on my PC, except for the .dat file in Drive C? It appears to run as a stand-alone exe file.

Thanks for helping this dumbbell.



Bitcoin Forum>Bitcoin>Development & Technical Discussion>Wallet software>Electrum
Jump to: