Get back to this..."Ethernet cord shows a solid orange light with periodically blinking green"
I am assuming you are running windows.....Open a command prompt and make sure your computer is on a 192.168.1.XXX IP address. Then try to access the blade again.
Topic: Erupter blade. Help! (Read 1231 times)
So is what you are saying is I should hook it up with the 2 Oranges that say 300V on each wire then I take the 4 Blacks(grounds) and plug 2 in each slow on the negative sides? Then hook up a couple fans to the PSU so it doesn't shot off when I turn it on.
Pretty much, yep.
So is what you are saying is I should hook it up with the 2 Oranges that say 300V on each wire then I take the 4 Blacks(grounds) and plug 2 in each slow on the negative sides? Then hook up a couple fans to the PSU so it doesn't shot off when I turn it on.
Running a Blade off a single Molex is dodgy, the Blade uses more power than the Molex's rating.
I run mine off a 6-pin PCI-E connector, which I made using a PCI-E extension cable. Cut off the male end, and connect the wires to the green Phoenix connector. Job done.
Some PSUs won't run with only a 12V load, they expect there to be some 5V load too - my old Zalman 1000W unit would run my Blades at all until I hooked up a few fans to the 5V line. Now I use a Corsair CX750 which runs perfectly with only a 12V load and nothing on the 5V.
If you're still stuck, I'll take a pic of mine this evening.
I run mine off a 6-pin PCI-E connector, which I made using a PCI-E extension cable. Cut off the male end, and connect the wires to the green Phoenix connector. Job done.
Some PSUs won't run with only a 12V load, they expect there to be some 5V load too - my old Zalman 1000W unit would run my Blades at all until I hooked up a few fans to the 5V line. Now I use a Corsair CX750 which runs perfectly with only a 12V load and nothing on the 5V.
If you're still stuck, I'll take a pic of mine this evening.
http://imgur.com/A9mN496">
http://imgur.com/jrQzk0O">
http://imgur.com/0L62FlM">
http://imgur.com/lZacQm8">
Delete messageDelete ReplyReply Reply with quoteQuote Notify of repliesNotify
8 Other / Newbies / Erupter Blade on: Today at 03:49:48 AM
I have an Erupter Blade that I got off E-bay it doesn't look like any of the models the guides are for it is a V2. I would upload an image but I do not know how yet in this forum. Anyways I bought a Y-Power Connector Cable it has 4 Blacks 2 Orange and 2 Red. The Red have no marking on them what so ever. The Orange on the other hand say 300V just like the Yellow cables on a Molex. When every I try to set it up like the guide with the oranges on the plus side and 2 blacks in each slot on the negative side. This makes the device blink a few times then it shuts down the PSU not good the PSU shuts down to protect devices. So then I tried 1 red on the positive side and one black on the negative side blinks a few times then stops blinking Ethernet cord shows a solid orange light with periodically blinking green. I tried connecting to the IP and Port but to no avail takes me straight to Bing.com Any help would be appreciated I am very new to mining and could use as much help as possible if someone would also inform me how to upload an image here it would be greatly appreciated.
I got the images thanks to another posters advice so disregard the no image stuff.
Jump to: