Firstly, I searched every article I could on this forum and couldn't find a solution. I then spoke for hours in Slush's IRC chat to no avail.
After hours of troubleshooting I'm still having the same problem, though I have a lot more detail on what is happening. In a nutshell the blades continuously switch between the listed Server Addresses.
I have Slush's mining_proxy.exe configured on two local computers - both desktops, both configured not to Sleep.
Total MHS: 05121
Received: 0000062580
Accepted: 0000040226
Per Minute: 070.82
Efficiency: 064.27%
Up Time: 0d,09h,28m,00s
Current Server: 10.1.10.11:8332
Chip: OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO
IP: 10.1.10.54
Mask: 255.255.255.0
Gateway: 10.1.10.1
WEB Port: 80
Primary DNS: 10.1.10.1
Secondary DNS: 10.1.10.1
Ports : 8332,8332
Server addresses : 10.1.10.11,10.1.10.10
user:pass : Any.worker1:xxxxxx,Any.worker1:xxxxxx
I have 10 blades on a backplane with an HP ATSN 7001044-Y000 979124-001 Power Supply, all of them act identical. They act the same weather I have 1 blade connected to the backplane or all 10.
I have tested switching out the proxy for 32bit bfgminer, linux bfgminer on a BBB, and different proxy software on each computer.
The voltage reads 12.81v, however I have not tested amperage as I'm not familiar enough with electricity to tinker that deep.
The blades to NOT restart - they just switch between the two servers (proxies) and remain around 5000 mh/s.
If I configure the blades with the same server separated by commas (e.g. 10.1.10.11,10.1.10.11), the blades will continuously reset after just over 2 minutes.
Happy to start up a Team Viewer Session if anyone is interested in poking around.
Many thanks to dmelvin, minigpenguin, MoonCat, bitguy, urgodfather, and honkeylips for helping me get this far.
Topic: Erupter Blade - Repeatedly Switching Proxy (Read 426 times)
Jump to: