Topic: Fake fan sensor problem.. need advice. (Read 224 times)
Thanks Dave.
Anyone know where can I get the Whatsminer M3 custom firmware that can ignore the fan speed check? Or I can only use the fake fan rpm sensor for immersion. Thanks for the advice.
2) This question comes up a lot.
https://www.techidiots.net/notes/fake-fan-sensor
If you are going to do an oil immersion just do a quick board like that.
There are a few on pre-made ones ebay and other places.
-Dave
Thank you Dave. I've seen this page before. The only thing I curious about is the M3 control board has 3pins slot. If I plug in the fake fan RPM sensor, will it be working like antminer S9.
https://imgur.com/TIriaM9
I've post new thread in the Mining support section and will delete this one soon. Thanks mate.
https://imgur.com/TIriaM9
I've post new thread in the Mining support section and will delete this one soon. Thanks mate.
As far as I know it will be fine, if you look at the picture it's just 3 wires. + and - and speed
https://www.techidiots.net/pictures/projects/fake-fan-sensor/20150213-213225.jpg
-Dave
Anyone know where can I get the Whatsminer M3 custom firmware that can ignore the fan speed check? Or I can only use the fake fan rpm sensor for immersion. Thanks for the advice.
Jump to: