Firmware for Dragonmints T1's and Bimtain t9's

thierry4wd

sr. member

Activity: 446

Merit: 347

Hi, obviously I'm not visible enough ... I offer my mod for T9+ for free available here:

https://drive.google.com/drive/folders/1yl0fym6ezHnKptGaHrWB6W2Rl2p9nwNp

WARNING, this is a mod, it unlocks the firmware, for this, you must first install a firmware before 2019 (if this is not already the case), then subsequently, update via the interface of the miner with my mod (929kb archive only).

You can start tuning at 650mhz and 840mv, the miner will run cooler, less power, and around 12TH

this mod is completely free;)

BitMaxz

legendary

Activity: 3472

Merit: 3217

Playbet.io - Crypto Casino and Sportsbook

For t1 firmware, there is a firmware share by someone here on the forum you can find the Dragonmint t1 firmware from here http://ck.kolivas.org/temp/
It was posted from here https://bitcointalksearch.org/topic/dragonmint-myrigcom-support-3731220

Or use the firmware shared by Biffa here https://bitcointalksearch.org/topic/m.56689163

About for T9, I can't find any 3rd party firmware but if your purpose is to fix the brick t9 miners then there are some ways to try to unbrick them.

Have you tried to flash it with an SD card using the "t9+-SD Tools.zip" I do not sure if it's compatible but you can try If not this one below is your last option

This is the 2nd option but it needs a cable called "USB to serial cable" you can check the guide from here https://bitcointalksearch.org/topic/rescuing-a-bricked-t9-and-s9-control-board-howto-2386296

MarsMiningCo

newbie

Activity: 19

Merit: 17

hi guys

I am looking for 3rd party firmware to see if i can upgrade on my T1's and T9's respectively. I saw some old posts that were talking about using BrainsOs on the T1's and read that people were having issues with this.

The T9's I have are not the pluses (T9+) and this firmware has bricked a couple of my units.

I found some 3rd party websites but they are asking for BTC donations; more likely a scam site.

open to any ideas

Thanks

Topic: Firmware for Dragonmints T1's and Bimtain t9's (Read 79 times)