Author

Topic: Flashing control Board S9 to R4 (Read 148 times)

hero member
Activity: 504
Merit: 1065
Crypto Swap Exchange
October 25, 2023, 06:42:40 PM
#5
Hello,
I recently purchased a control board that said it would work with my R4, It's a  ZYNQ C41   IT has the S9  firmware installed.   When I go to flash it with the R4 TAR.GZ files, it gives me an error.  I am not sure if there is a different file I can use to flash it or make a file for a bootable SD card.   The files on Bitmain don't seem to be files I can use to boot from the sd card.  Any help is greatly appreciated!   I don't think this should be this complicated.  Thank you in advance. 

Yeah as mentioned by Artemis3, you should follow these exact steps :

S9-Control-Board-Program-Recovery

Once done you just need to flash again your board with the R4's firmware (from the GUI).
legendary
Activity: 2030
Merit: 1573
CLEAN non GPL infringing code made in Rust lang
October 22, 2023, 01:50:12 PM
#4
Needs to use the old trick of using "t9+ -SD Tools.zip" to remove the signed only fw or use one of the unlockers...
member
Activity: 66
Merit: 18
October 09, 2023, 12:06:58 AM
#3
Zynq IS a XILINX Board. Bitmain has a few R4 Firmwares on their support page - flash it with the XILINX or the "All Auto-Freq" GZIP files.
legendary
Activity: 3472
Merit: 3217
Playbet.io - Crypto Casino and Sportsbook
October 05, 2023, 01:56:58 PM
#2
Who said that it would work in r4 units?
Pretty bad you bought a c5 control board I never heard that c5 control will work in R4.
The control board that you should buy is the Xilinx control board because it's universal.


Also, I checked Bitmain's download page they don't have SD card firmware for r4 units so the firmware you download can only be flashed on the dashboard GUI. You can try to flash it through the browser let see if it would work.
newbie
Activity: 1
Merit: 0
October 05, 2023, 09:14:14 AM
#1
Hello,
I recently purchased a control board that said it would work with my R4, It's a  ZYNQ C41   IT has the S9  firmware installed.   When I go to flash it with the R4 TAR.GZ files, it gives me an error.  I am not sure if there is a different file I can use to flash it or make a file for a bootable SD card.   The files on Bitmain don't seem to be files I can use to boot from the sd card.  Any help is greatly appreciated!   I don't think this should be this complicated.  Thank you in advance. 


Rob
Jump to: