Author

Topic: For Sale 1987 Toyota Cressida MX73 and 1991 Toyota Cressida MX83 (Read 4183 times)

full member
Activity: 201
Merit: 100
maybe.

Dont even know what to say, you can have the shell for the 91 for $500??? The engine and transmission for another $5,000...anyways

Have a few people coming over to look at the 87 and the engine out of the 91 this weekend. Will post if anything sells.

Also have a LS7 engine and 6-Speed T-56 transmission I may be putting up for sale soon. Engine is fully built with a 4.125" bore, 4.25" stroker crank, Wiseco Pistons, 4340 forged-steel crank, 6.125-inch  K1 Technologies H-beam rods, Clevite main bearings, coated rod bearings from Federal Mogul, hydraulic rollers 0.660 lift w/ factory 1.8 ration LS7 rockers, comp cam 251/266 cam, Trick flow genx 245 ported heads. Strengthening the bottom end as always is a set of ARP main studs. Compression is at 11.8:1 and was being built to be tame when needed and also a hell raiser at night. Engine put out a little over 725hp at the crank.

Total cost of engine build $30,000, if I end up actually letting it go it will be in the range of $35,000 with the transmission. The engine has been broken in on an engine dyno and never been installed in a car. Transmission is from a second gen GTO that had 25k miles on it before it made friends to a wall out here at Atlanta Motor Speedway. Will come with a ACT twin clutch setup with stock flywheel to cut back on noise.
full member
Activity: 201
Merit: 100
full member
Activity: 168
Merit: 100
550 for the first one.
full member
Activity: 201
Merit: 100
full member
Activity: 201
Merit: 100
Ive seen crazier things for sale on here, so I figured I would throw my Cressidas up here to see if anyone would be interested. Motivated to sell, prices are OBO, and willing to make BTC. Also just a FYI, cars are located in Dacula, GA about 2 miles away from Mall of Georgia.

First up is the 1991

What I have here is a 1991 Toyota Cressida with a 1JZGTE swap in it with a 2JZ auto transmission and a 2800 stall. Here is the history about the car:

I purchased the car 3 years ago. The car was said to only need a few wires run and that was it. I purchased the car and sent it over to Garage Zero. John over at GZ got the wiring done and when I went over to hear it start up for the first time the car just turned over and that was it.

After a few days of swapping out parts and checking everything we could we found out that the ECU had some blown caps so we ordered a new ECU. Once the ECU came in the car started up just fine and ran great. I went over to pick the car up and put it in reverse and guess what, there was no click. We pushed the car back and then I put it into drive to at least get it out of the shop. It clicked into drive but it was 2nd gear. I got the car out of the shop and home, with only 2nd gear and a slipping 3rd, and the car sat.

After a few weeks I found a 2JZ tranny that was built with a 2800 stall for sale. The transmission was still in the car so I went over and tested it out and told the guy I wanted it. He pulled the transmission out and I was on my way to swapping mine out.

After figuring out that I needed a LOT more than just the transmission, tail shaft, flywheel, ect, I finally was able to swap everything out. I put the new transmission in and not thinking went to hook the drive shaft up and nope, need something else. Custom drive shaft.

I got the drive shaft made, but am having trouble getting the correct pitch from the engine/transmission to the rear end. This is where the car is right now. I am tired and done with this car and with school tuition approaching again I am just going to cut my losses and say goodbye. Here is a list of what I know need to be done to the car to get it back on the road:

Get correct pitch from transmission to drive shaft
Hook drive shaft up
modify shift linkage (bend it) so it clears drive shaft
fill transmission with fluid
purchase intake filter
tires are dry rotten and shot so get tires
build exhaust
DRIVE!!!

The car drove great that one time I was able to bring it home from the shop, only in 2nd gear at least. Per the previous owner the engine had between 60k-65k miles, not sure if I believe him but thats what I was told. The new transmission had less than 10k on the rebuild.

Inside the car everything is there. The glove compartment is pulled out on the passenger side at the moment so we could get to the ECU, but it should only take a few moments to get that all put back together.

One final note. I know what the engine/transmission costs in this car. Do not try to low ball me on this. If I have to I will take the engine and transmission out and sell them separately and junk the shell. For more information or pictures or to view the car email me or call me. Also you can talk to John over at Garage Zero in Norcross about the car, he is very familiar with it.

Title in hand

To get the ball rolling:
Asking Price $5500 obo

CAR COMES WITH OZ RACING RIMS NOT THE WHITE ONES SHOWN IN PICTURES ABOVE, THEY WERE STOLEN A WHILE BACK

For more info or pictures feel free to contact me
[email protected]
David McNamara







MOST RECENT ENGINE BAY PICS TO SHOW IC PIPE IS DONE






1987 Toyota Cressida

1987 Toyota Cressida
Chassis shows 300,xxx miles
Engine/Transmission from a 1982 Supra w/ 100k miles
16x8 0 offset XXR 522 wheels
Tien Coilovers in rear, stock up front w/ GC kit
Straight pipe exhaust (been repaired 10-20 times under the car due to height)
FD RX7 Oil Cooler w/ goodyear hoses
Oil Filter relocation kit
Yakima old skool rack (with keys and 1 bike bar)
EGR delete

Good:
-Transmission shifts smooth
-Interior in great condition (minus the one hold in the dash where the previous owner had a stupid tach)
-Heated mirrors still work!!!
-New timing belt, plugs, wires, fuel pump less than 500 miles ago
-All new seals (HG, Oil pan, cam, etc)
-No rust

Bad:
-Blower motor went out
     Heat worked and a/c worked when the blower was working. The a/c did need a recharge every year, but it did work
-Sunroof stopped working
     Never worked since I purchased the car 5 years ago
-Engine smokes a little

I know I am forgetting a TON but I needed to start this thread now while I had the pictures. When I get home I will take more pictures of the inside and outside. I will also verify the mileage on the chassis.

Price: $4500obo
Contact:
David McNamara
[email protected]

Car located in Dacula, GA








Newer Engine that was put in the car

Jump to: