Just curious.
Where did you order the control board? How much is it?
thanks.
Topic: Green light but no Orange light.... (Read 853 times)
Tried pretty much everything.
IP scanners, PUTTY. reset switch, power supplies, cables, router, hub, direct connection, computer.... Nothing would see the S1 as connected
Something on the control board to do with network connection must be bad I guess.
So I ordered a new control board.
Installed it.
Plugged in cables.
Entered mining settings.
Back up and running.
Whew!
Thank you all for the advice.
IP scanners, PUTTY. reset switch, power supplies, cables, router, hub, direct connection, computer.... Nothing would see the S1 as connected
Something on the control board to do with network connection must be bad I guess.
So I ordered a new control board.
Installed it.
Plugged in cables.
Entered mining settings.
Back up and running.
Whew!
Thank you all for the advice.
This happened to one of my ant s1s
After I change the USB hubs and got a direct connection from miner to computer, all is good. Not sure which one exactly solved the problem since I did both at the same time.
After I change the USB hubs and got a direct connection from miner to computer, all is good. Not sure which one exactly solved the problem since I did both at the same time.
Multiple S1s with the same IP address may cause this problem.
What is your router IP address? Typical router IP address is 192.168.1.1. If your S1's gateway isn't set to the router's IP address, then it won't see network.
Can your router see the S1? Router typically has a diagnostic screen that shows what's attached to the router network.
I configure the S1 with a direct connection from computer to S1 using network cable, without going through router or switches. This will eliminate many potential problems.
What is your router IP address? Typical router IP address is 192.168.1.1. If your S1's gateway isn't set to the router's IP address, then it won't see network.
Can your router see the S1? Router typically has a diagnostic screen that shows what's attached to the router network.
I configure the S1 with a direct connection from computer to S1 using network cable, without going through router or switches. This will eliminate many potential problems.
Have you tried the reset button on the control module? This will reset to default IP settings.
Not sure if I'm in the right place or not....
But does anyone know where I might be able to purchase a new control board for the Antminer S1?
Or if anyone knows another way to use the blades?
The S1 turns on but it can't see the network.
The green light on the network cable plug turns on and flashes. But the orange light does nothing....
Replaced network cables, tried different hubs and routers.... same issue. Tried different power supplies.
Turned off for hours then turned on. Sometimes connects only to disconnect few minutes later.
Any ideas?
But does anyone know where I might be able to purchase a new control board for the Antminer S1?
Or if anyone knows another way to use the blades?
The S1 turns on but it can't see the network.
The green light on the network cable plug turns on and flashes. But the orange light does nothing....
Replaced network cables, tried different hubs and routers.... same issue. Tried different power supplies.
Turned off for hours then turned on. Sometimes connects only to disconnect few minutes later.
Any ideas?
Jump to: