replay everything that u did to that miner if you are sure that its physical damage.
maybe a longshot, but do u have those modified usb drivers correctly set up ?
Topic: Gridseed Repair? (Read 744 times)
most resellers have a warrenty, so if out of warrenty, buy a new unit, wait a few days, then send the faulty unit back
after all they all look the same to a consumer so how can you tell which one died. i think the second one died, so you should send the dead one back
after all they all look the same to a consumer so how can you tell which one died. i think the second one died, so you should send the dead one back
I was curious if anyone does any repair on these. Or if not, if you might have an idea of what might be wrong with mine. I have 4 which just stopped working. They still have the fans on and were only running scrypt. There are no visible signs of damage. when 12v is connected the fan spins, but it never detects the USB plugged in and so the lights never come on. If I jump two of the pins on u10 near the com port. My computer will detect that it was plugged into the usb, but doesn't know what it is. My drivers are good as I currently have 3 others still hashing away on the same computer. It is apparently something with the 5v side, just not sure what, All are the 2nd gen with the newer com port firmware. I am lost. Any help or ideas of where to look or where to get parts for these other than other dead units would be greatly appreciated. Thanks!PS. I was able to solder the two pins on u10 mentioned above on two of the units and they are alive! lights on, hashing away, no HW errors. What is up with these other ones? What most commonly goes out on these units?
Jump to: