That was my problem!
Everything is normalized now. That'll teach me to mess with the config files, and not reboot immediately! 
Topic: Hash rate changes with line voltage??? (Read 711 times)
^^^^^^
That was my problem! Everything is normalized now. That'll teach me to mess with the config files, and not reboot immediately!
That was my problem!
Everything is normalized now. That'll teach me to mess with the config files, and not reboot immediately! 
Just curious if anyone has ever experienced this or has known of it happening. Last night, both of my miners were working along at their stable (expected) hash rates, and then we had a momentary black-out that caused them both to shutdown. I had them both rebooted in a matter of minutes, and didn't pay much attention to the hash rate of each card, just that they were restarting, and working. Several hours passed, and when I checked back, all 7 of my cards are now operating at about 4 - 5 MH/s slower than they were before the power outage. This is spread across 7 different cards, 2 different motherboards, and 2 different PSU's. The only two common points that I can some up with are the pool that they connect to and the plug in the wall that supply's power. I would have thought that regulated PSU's would deliver the same DC voltage, regardless of input (within tolerance). Looking at my Kill-a-watt, it shows a max Vac of 124.5 and a current Vac of 113.8, so I know that there has been some fluctuation on the line at some point.
I don't think so.
I would not trust kill-a-watt, it has 10% tolerance.
PSU better deliver 5V and 12V no matter what the swing on the line is (to a degree).
Is your network connection ok? Same or slower. Run speedtest.net
Temperature outside, inside (the cases)?
BTW, 4-5 MH/s is not much, it could be just a variance.
I think I found my problem! 
I remember looking into changing the kernel for the GPU's and I obviously edited the config files for a different kernel, and never re-started cgminer before the power went out. Just changed the kernels and restarted. Waiting to see where they settle now.
I remember looking into changing the kernel for the GPU's and I obviously edited the config files for a different kernel, and never re-started cgminer before the power went out. Just changed the kernels and restarted. Waiting to see where they settle now.
Just curious if anyone has ever experienced this or has known of it happening. Last night, both of my miners were working along at their stable (expected) hash rates, and then we had a momentary black-out that caused them both to shutdown. I had them both rebooted in a matter of minutes, and didn't pay much attention to the hash rate of each card, just that they were restarting, and working. Several hours passed, and when I checked back, all 7 of my cards are now operating at about 4 - 5 MH/s slower than they were before the power outage. This is spread across 7 different cards, 2 different motherboards, and 2 different PSU's. The only two common points that I can some up with are the pool that they connect to and the plug in the wall that supply's power. I would have thought that regulated PSU's would deliver the same DC voltage, regardless of input (within tolerance). Looking at my Kill-a-watt, it shows a max Vac of 124.5 and a current Vac of 113.8, so I know that there has been some fluctuation on the line at some point.
Jump to: