I only asked, because I could not find an answer after searching this and other forums.
I actually only joined this forum, because it was the only way to be able to ask.
While the answer was not here, and no assistance was offered, I was in the mean time able to figure it out.
Until such time as the S4s stop earning more than the electricity they are using, I will keep them running.
Though this is likely to occur in the near future.
Topic: Help Please - S4 Stopped Working (Read 733 times)
Try searching for answers in the s4 threads in the hardware section. That is ancient hardware and few folks still run them. I took mine offline over 2 years ago...
I think is related to the beaglebone at this point.
Does the S4 just run of the sd card or is there firmware loaded to the beaglebone?
If I get a replacement beaglebone, is there something I have to do to make it work specifically for
this S4?
Does the S4 just run of the sd card or is there firmware loaded to the beaglebone?
If I get a replacement beaglebone, is there something I have to do to make it work specifically for
this S4?
I have an S4 that stopped working.
It starts up like normal, but then has temp 0, hash 0.
The IP address that shows up on the screen, is not accessible.
I cannot ping it or connect to it in any way.
The router does not show that the device is even connected.
All the network lights indicate that it is connected.
I have tried multiple versions of the SD card images, and they all function the same way.
All cables and lights seem normal, other than the lights next to the LCD screen. The green light
comes on and stays on till the status shows up, then it is dark.
The factory reset does absolutely nothing.
I have tried different routers and network cables.
Any suggestions?
It starts up like normal, but then has temp 0, hash 0.
The IP address that shows up on the screen, is not accessible.
I cannot ping it or connect to it in any way.
The router does not show that the device is even connected.
All the network lights indicate that it is connected.
I have tried multiple versions of the SD card images, and they all function the same way.
All cables and lights seem normal, other than the lights next to the LCD screen. The green light
comes on and stays on till the status shows up, then it is dark.
The factory reset does absolutely nothing.
I have tried different routers and network cables.
Any suggestions?
Jump to: