https://bitcointalksearch.org/topic/m.56976860
Username moinmanek147
Telegram username moinmanek147
FACEBOOK username moinmanek
Topic: Help S9 firmware flash issue, works, but stalls when pool changed (Read 130 times)
Buena idea
Update fixed. Both stratum I was using were dead, went to another pool host and it worked bit only after 20 min on the stock antpools. Figured this out by repeating test.
Today for no known reason my S9 wouldn't spool up after 45 min it wouldn't load and start hashing when I plugged it in today. It has been working fine for a month. It was new never used sealed in box. I reflashed firmware with keep settings to 2017 firmware. Same after 45 min. I did sd card t9+ recovery, flashed 2017 firmware unchecked keep settings and it spools up In the usual 5 minutes but to the stock antpool addresses.
When I change the pool addresses it goes back to hanging for 45+min. When I reflash and uncheck keep settings it fires right up. Change pools and hangs.
I let it run for 20min on the stock pools after reflashing and tried a completely differnt pool and same.
Any ideas?
When I change the pool addresses it goes back to hanging for 45+min. When I reflash and uncheck keep settings it fires right up. Change pools and hangs.
I let it run for 20min on the stock pools after reflashing and tried a completely differnt pool and same.
Any ideas?
Jump to: