PM me if still need help..
best regards
Topic: Help w/ Block Erupter Blade V2 Power Issue (Read 449 times)
hi in first you have to ensure your psu provide enought power.. , and in a second time try a harware reset;
PM me if still need help..
best regards
PM me if still need help..
best regards
After finally getting my Block Erupter Blade up and running, it has started to restart at almost exactly 10 minutes, every 10 minutes. Additionally, there are 3 x's present in the "Chip" line on the configuration page. These are shown in the screenshot below
http://gyazo.com/7ecff364517773124131ed711ec165aa
I have been told that this means there is an issue in one of the power lanes, but that I cannot manually fix this issue due to the absence of power modifiers for each individual lane. I am hoping someone with more knowledge of the Blade can possibly help me out in finding a solution to this issue.
I thank anyone in advance who can possibly help me out, and I will provide any additional information if needed.
http://gyazo.com/7ecff364517773124131ed711ec165aa
I have been told that this means there is an issue in one of the power lanes, but that I cannot manually fix this issue due to the absence of power modifiers for each individual lane. I am hoping someone with more knowledge of the Blade can possibly help me out in finding a solution to this issue.
I thank anyone in advance who can possibly help me out, and I will provide any additional information if needed.
Jump to: