Topic: How can I get a power cord for my Avalone 2x741 power supply? (Read 444 times)
No, because the draw of each Avalon is approximately 5 amps, so 4 will have you tripping the breaker. When I went up to 4 units I upgraded to a 30 amp circuit, and then a PDU.
November 08, 2017, 03:21:25 PM
@Phil: i think 30A pdu should work with 20a outlet. 30A is how much load the PDU could handle, and our outlet only provide maximum of 20A. Correct me if im wrong.
Well here is the deal. a 30 amp pdu can have 24 amp hooked up to it 24/7/365
if you swap out the plug it will connect to your 20 amp circuit and if you do 3 avalon 741's you are fine if you load the 4th one you are not fine.
but if you get this
https://www.ebay.com/itm/Conntek-55705-Power-Strip-250-Volt-7-1-2-Inch-Housing-IEC-C14-Inlet-to-4-IEC-C13/292190479200?
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
you can do 2 avalon 741's
you can use up to 15amps on the setup. and 2 avalon 741's are about 9-11 amps
with this outlet in your place
Phil, i measured my outlet last night, it's 240V, 20A. So it will provide me 240x20 = 4800W. that mean I could run up to 4 Avalon right?
@Phil: i think 30A pdu should work with 20a outlet. 30A is how much load the PDU could handle, and our outlet only provide maximum of 20A. Correct me if im wrong.
Well here is the deal. a 30 amp pdu can have 24 amp hooked up to it 24/7/365
if you swap out the plug it will connect to your 20 amp circuit and if you do 3 avalon 741's you are fine if you load the 4th one you are not fine.
but if you get this
https://www.ebay.com/itm/Conntek-55705-Power-Strip-250-Volt-7-1-2-Inch-Housing-IEC-C14-Inlet-to-4-IEC-C13/292190479200?
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
you can do 2 avalon 741's
you can use up to 15amps on the setup. and 2 avalon 741's are about 9-11 amps
with this outlet in your place
What type of PSU are you using? You might not need a PDU as you won't have a lot of room to expand your mine off that outlet anyways, tops one more Avalon 741.
https://m.ebay.ca/itm/Power-Supply-for-Two-x2-Antminer-S9-S7-L3-with-Ready-To-Plug-Harness/182254895754?hash=item2a6f3d028a:g:cWQAAOSwaB5XrNj2
Here is an option, it even leaves a little room for more powerful miners in the future. They are good to deal with and can give you a lot of useful information.
https://m.ebay.ca/itm/Power-Supply-for-Two-x2-Antminer-S9-S7-L3-with-Ready-To-Plug-Harness/182254895754?hash=item2a6f3d028a:g:cWQAAOSwaB5XrNj2
Here is an option, it even leaves a little room for more powerful miners in the future. They are good to deal with and can give you a lot of useful information.
im using 2x650W PSU for computer to power up the Avalon.
@Phil: i think 30A pdu should work with 20a outlet. 30A is how much load the PDU could handle, and our outlet only provide maximum of 20A. Correct me if im wrong.
wait for link
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
https://www.amazon.com/NEMA-6-20P-C19-Power-Cord/dp/B004WJRAUI/ref=sr_1_2?
these will connect to most psu's
you have a nema 6-20r outlet see wiki
https://en.wikipedia.org/wiki/IEC_60320
your psu most likely is a c19 or c20
wow!!!
philipma1957 is really the must skilled man in this field!!!
thank you very much for the image!!!
really clear!!
I just got my Avalons 741x2. There is an outlet inside my apartment look like the picture below. I usually use it for my AC unit. Can someone advise me where to buy a cord to connect the PSU to the wall to run 2 Avalon.
Please help.
Please help.
wait for link
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
https://www.amazon.com/NEMA-6-20P-C19-Power-Cord/dp/B004WJRAUI/ref=sr_1_2?
these will connect to most psu's
you have a nema 6-20r outlet see wiki
https://en.wikipedia.org/wiki/IEC_60320
your psu most likely is a c19 or c20
https://www.ebay.com/itm/Dell-Power-Distribution-Unit-PDU-208V-30A-L6-30P-Input-21xC13-6xC19-Output-10CXM/361638191527?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
That pdu is for a 30 amp circuit you have a 20 amp plug. Like me look for some links
What type of PSU are you using? You might not need a PDU as you won't have a lot of room to expand your mine off that outlet anyways, tops one more Avalon 741.
https://m.ebay.ca/itm/Power-Supply-for-Two-x2-Antminer-S9-S7-L3-with-Ready-To-Plug-Harness/182254895754?hash=item2a6f3d028a:g:cWQAAOSwaB5XrNj2
Here is an option, it even leaves a little room for more powerful miners in the future. They are good to deal with and can give you a lot of useful information.
https://m.ebay.ca/itm/Power-Supply-for-Two-x2-Antminer-S9-S7-L3-with-Ready-To-Plug-Harness/182254895754?hash=item2a6f3d028a:g:cWQAAOSwaB5XrNj2
Here is an option, it even leaves a little room for more powerful miners in the future. They are good to deal with and can give you a lot of useful information.
I just got my Avalons 741x2. There is an outlet inside my apartment look like the picture below. I usually use it for my AC unit. Can someone advise me where to buy a cord to connect the PSU to the wall to run 2 Avalon.
Please help.
Please help.
wait for link
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
https://www.amazon.com/NEMA-6-20P-C19-Power-Cord/dp/B004WJRAUI/ref=sr_1_2?
these will connect to most psu's
you have a nema 6-20r outlet see wiki
https://en.wikipedia.org/wiki/IEC_60320
your psu most likely is a c19 or c20
https://www.ebay.com/itm/Dell-Power-Distribution-Unit-PDU-208V-30A-L6-30P-Input-21xC13-6xC19-Output-10CXM/361638191527?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
I just got my Avalons 741x2. There is an outlet inside my apartment look like the picture below. I usually use it for my AC unit. Can someone advise me where to buy a cord to connect the PSU to the wall to run 2 Avalon.
Please help.
Please help.
wait for link
https://www.amazon.com/NEMA-6-20P-C13-Power-Cord/dp/B004WJNVH4/ref=sr_1_3?
https://www.amazon.com/NEMA-6-20P-C19-Power-Cord/dp/B004WJRAUI/ref=sr_1_2?
these will connect to most psu's
you have a nema 6-20r outlet see wiki
https://en.wikipedia.org/wiki/IEC_60320
your psu most likely is a c19 or c20
I just got my Avalons 741x2. There is an outlet inside my apartment look like the picture below. I usually use it for my AC unit. Can someone advise me where to buy a cord to connect the PSU to the wall to run 2 Avalon.
Please help.
Please help.
Jump to: