try older version of cgminer
http://ck.kolivas.org/apps/cgminer/2.11/
Topic: Icarus Board dosnt get detected in cgminer when i use WinUSB (Read 2478 times)
ok with driver PL2303_prolific_driverinstall_v1.8.0 installed i get an error with cgminer 3.3.0
USB init,open device failed, err-12 you need to install a WinUSB driver for - ICA device 2:3
if i change the driver to winusb then i get no device detected
USB init,open device failed, err-12 you need to install a WinUSB driver for - ICA device 2:3
if i change the driver to winusb then i get no device detected
cgminer version? I though it had builtin drivers for fpga but I dont use windows for mining so I dont know
are you sure? PL2303_Prolific_DriverInstaller_v1.8.0.zip
are you sure? PL2303_Prolific_DriverInstaller_v1.8.0.zip
yep tried them drivers and cgminer tells me i need to install winusb
or am i missing something?
or am i missing something?
here is the driver you need, go to this page
http://www.prolific.com.tw/US/supportDownload.aspx?FileType=56&FileID=133&pcid=85&Page=0
if it asks for a LOGIN name, just use guest/guest as username and password
or you can try direct link here:
http://www.prolific.com.tw/admin/Technology/GetFile.ashx?fileID=232
http://www.prolific.com.tw/US/supportDownload.aspx?FileType=56&FileID=133&pcid=85&Page=0
if it asks for a LOGIN name, just use guest/guest as username and password
or you can try direct link here:
http://www.prolific.com.tw/admin/Technology/GetFile.ashx?fileID=232
ok so iv been messing around trying to get an Icarus Board to work (pretty new to FPGA) it gets detected when i use the driver Prolific and cgminer then tell me i need to install WinUSB driver i then install WinUSB driver and run cgminer again and it then says no Device found, i check Device manager and its there as
USB-Serial Controller D
anyone got any ideas??? its given me a headache trying to figure this out (i also really really hate anything to do with command line)
USB-Serial Controller D
anyone got any ideas??? its given me a headache trying to figure this out (i also really really hate anything to do with command line)
Jump to: