Another tech tried to help last night. Still same issue. It's hashing so I'm not gonna worry too much. Just can't update it.
Topic: Innosilicon A4+ problem (Read 93 times)
After making the latest firmware update of my innosilicon device, the device gives an invalid hardware message. hardware G19 and the information below can not be displayed. The problem is not solved even though I installed the software in the older version.
same as wease
same as wease
Tech support tried to help and said I have a bad control board. It's hashing now but can't upgrade firmware. The system page says my hardware version is 17. Firmware upgrades fail and say invalid hardware. Its mining so I'm not as concerned right now.
https://bitcointalksearch.org/topic/innosilicon-a4-setup-tutorial-2549898
Quote
Add web API Management support on Miner for "Awesome Miner monitor"
telnet to your Miner IP and port 8100 with root and your new password
type "cd /home/inno_py/"
type "cp /home/inno_py/inno_config.py ./inno_config.py.bk" to take a backup of your file before editing
type "vi /home/inno_py/inno_config.py" to erdit your config file
scroll down until you see the value gInnoInitCmdStr
click the letter i on the keyboard to enable edit mode in vi
at the end of that line replace "--api-listen" with "--api-listen --api-network --api-allow W:0/0" this will enable network privileged access from API
Click "ESC" on the keyboard to exit Edit Mode
click ":wq" and Enter to save the file
type reboot to reboot your miner and for changes to take effect
telnet to your Miner IP and port 8100 with root and your new password
type "cd /home/inno_py/"
type "cp /home/inno_py/inno_config.py ./inno_config.py.bk" to take a backup of your file before editing
type "vi /home/inno_py/inno_config.py" to erdit your config file
scroll down until you see the value gInnoInitCmdStr
click the letter i on the keyboard to enable edit mode in vi
at the end of that line replace "--api-listen" with "--api-listen --api-network --api-allow W:0/0" this will enable network privileged access from API
Click "ESC" on the keyboard to exit Edit Mode
click ":wq" and Enter to save the file
type reboot to reboot your miner and for changes to take effect
Can someone give me the original line where api-listen is? Im pretty sure I screwed up when trying to change it and can't seem to fix it. I remember doing a backup when I set the api before but don't know how to put in the backup file. Innosilicon hasn't responded back to me yet.
I just upgraded firmware and tried to configure api again and messed something up. I can access miner page but it just keeps loading. Can't upload firmware again. No card reader just an empty slot where it should be. How do I fix this? I can still access it with telnet. Not sure what to do once in there to fix issue.
Jump to: