Yeah, i did get it from a second hand vendor. The Control board seems to be a non original one but still compatible. When i got the miner i was getting the full 660, the slowly went down to just 1 board.
Topic: Innosilicon A4+/A6 RESET failed (Read 127 times)
I reached out to innosilicon support center and they told me that the control board wasn´t original and didnt recognize the hashboards.
Next week would do a remote session to confirm.
Next week would do a remote session to confirm.
how did you end up buying an allegedly fake board? did you buy from second hand market?
sounds terrible if that's the case. maybe try to buy it directly from the distributor next time to avoid thing like this from happening. and it will be easier for you to claim guarantee or anything similar in case things happens.
sounds terrible if that's the case. maybe try to buy it directly from the distributor next time to avoid thing like this from happening. and it will be easier for you to claim guarantee or anything similar in case things happens.
Hi,
I purchased a lot of A4+ LTCMasters recently, over the past 8 weeks boards have been disappearing most randomly.
They all have the same general logs:
chain1: the plat is inserted
chain1: power down
chain1: set vid 0
chain1: set spi speed 0
chain1: encore first mode
ERROR - failed to recv spi data
chain1: RESET failed
All the obvious things have been tried without success.
Does anyone recognize what's actually happening?
I purchased a lot of A4+ LTCMasters recently, over the past 8 weeks boards have been disappearing most randomly.
They all have the same general logs:
chain1: the plat is inserted
chain1: power down
chain1: set vid 0
chain1: set spi speed 0
chain1: encore first mode
ERROR - failed to recv spi data
chain1: RESET failed
All the obvious things have been tried without success.
Does anyone recognize what's actually happening?
Jump to: