Topic: K16 Klondike not getting optimal speeds (Read 1503 times)

I have the same problem. Is it possible to check what firmware you have without buying a programmer?

I have a similar problem.

Best solution that I have found is to compile cgminer (I'm using 3.8.2 on a linux machine), with Line 58 and 59, # DEFINA_REPLY_WAIT_TIME set to 25 and the following line (or thereabouts), #define CMD_REPLY_RETRY = 4 (program has it at .
Also change line 63 #define KLN_KILLWORK_TEMP to 61.5 and set your bat file to 350, 55. (This is in the klondike.c file, thanks to Zipju and other people for the suggestion, also check projectklondike.org)

The other trick that I have found helps, is start CG_miner with only ONE Klondike.

Let that run maybe 30 seconds, until it gets up to it's maximum hash rate 5.5 Gh/s or more at 350 Mhz.

Then plug in one more (or two more), connect those to the USB hub, unplug and plug in the little fan connector.

Let those get up to maximum hash rate.

Rinse and repeat. Make a note of the KLN number in CGminer, so you know which ones to power cycle back on if the hash rate is too low. Rinse and repeat again.

Most of the time, that will work just fine. If I try to start up all 10 of mine, all at once, two of them at least will have exactly ZERO work units or accepted units, but will display 5+ Gh/s hashing, just no work units. Highly annoying.

In any case, one or two will sometimes hash at half/hash rate. It is annoying, but they are prototype units and you are on the bleeding edge.

If that doesn't work, I usually throw them on my windows machine and let that screw with it for a bit. Some of them seem to work better on Linux than Windows, others work better on Windows....go figure !

Welcome to high BTC prices.

The latest version of cgminer detects my K16s, but I have the same slow hashrate issue.   What's odd is they seem to perform better running solo than when combined on the same machine.
Do I special version of cgminer for windows built with klondike support, or does the latest version have that built in already?

I still don't get any higher speed even though I bumped it up, plus one of them (the one that gave me normal speed) gets 0 GH/s everytime I restart cgminer, sucks. I asked the assembler if he put the right firmware on it. I dont have the tools to update the firmware. Seems like its only using 1/2 the chips on one of the circuits, (mitten mining assembler)

No problem. I let mine run at that speed for a week and they ran stable so I bumped it up to 360:65 and pointed a box fan at the back to help with cooling, now all 3 together avg 17.05Gh/s.

thanks for the tip, I'll be sure to try it

what does "went idle before work was sent" mean?

try adding --klondike-options 350:65 to your .bat file. I use this for all 3 of my Klondike K16's and I get 5.5-5.6Gh/s each. If you need more help let me know.

it shouldnt need any parameters with the newer cgminer. could be worth checking its keeping cool and make sure its getting enough power. im not really familiar with this device so dont really know what else to suggest without screen shots

My klondike k16 which is rated at 4.5 GH/s,

is there a special cgminer set of parameters I need to achieve 4.5 GH/s??
Right now its only getting around 2-2.6 GH/s

I have zadig drivers and cgminer compiled for windows with klondike enabled,
would it be faster in linux?