Author

Topic: KNC Titan help - Firmware (Read 444 times)

legendary
Activity: 3178
Merit: 3295
July 07, 2018, 07:14:31 AM
#5
Hi to every one.

I have the same problem but unfortunately the link suggested on Cryptopia in not valid anymore ( crypto-is close the help center service )

Can you direct or contact me in order to have some indication?

Best Regards

I look what i can do to get the links from the thread from a Dev !  If i get it i will post it here .

Regards Lafu
newbie
Activity: 3
Merit: 0
July 05, 2018, 11:40:32 PM
#4
Hi to every one.

I have the same problem but unfortunately the link suggested on Cryptopia in not valid anymore ( crypto-is close the help center service )

Can you direct or contact me in order to have some indication?

Best Regards
full member
Activity: 188
Merit: 104
January 13, 2017, 10:57:22 AM
#3
Looking to see if anyone can point me in the right direction regarding reinstalling the Firmware image on to the SD card.  KNC's site is not up any longer and I can't find instructions on how to do it or even find the firmware image itself.  Reason I am looking is my Batch 1 Titan stopped working, controller screen is just blank.  Would like to try and reflash the firmware image to the SD and make sure its ok before I write off the controller as being bad.  Thanks for any help.

I have somthing for you thats help   !  get here and you found all the firmewares  cheers  https://www.cryptopia.co.nz/Forum/Thread/1046


Thanks!  I had finally found a download for 2.0 and got it flashed.  Good news is my controller lit up, showed the IP address, etc. and I can access the control panel but so far I can't seem to get it to hash.  Says its running and pool shows its connected but 0 speed.  So making some progress but not quite there yet.
legendary
Activity: 3178
Merit: 3295
January 12, 2017, 06:06:31 PM
#2
Looking to see if anyone can point me in the right direction regarding reinstalling the Firmware image on to the SD card.  KNC's site is not up any longer and I can't find instructions on how to do it or even find the firmware image itself.  Reason I am looking is my Batch 1 Titan stopped working, controller screen is just blank.  Would like to try and reflash the firmware image to the SD and make sure its ok before I write off the controller as being bad.  Thanks for any help.

I have somthing for you thats help   !  get here and you found all the firmewares  cheers  https://www.cryptopia.co.nz/Forum/Thread/1046
full member
Activity: 188
Merit: 104
January 12, 2017, 05:17:58 PM
#1
Looking to see if anyone can point me in the right direction regarding reinstalling the Firmware image on to the SD card.  KNC's site is not up any longer and I can't find instructions on how to do it or even find the firmware image itself.  Reason I am looking is my Batch 1 Titan stopped working, controller screen is just blank.  Would like to try and reflash the firmware image to the SD and make sure its ok before I write off the controller as being bad.  Thanks for any help.
Jump to: