this thread helped me quite a bit:
https://bitcointalksearch.org/topic/guidehow-to-setup-an-automated-headless-linuxcoin-mining-rig-watchdog-29021
Topic: Linuxcoin help (Read 1948 times)
You could write a script that parses the output of aticonfig and run it every x seconds. For example, will give you the load. If it's not 99%, card is not used...
Code:
aticonfig --adapter=ID --odgc | grep 'GPU load' | awk '{ print $4; }'I just watch the temps to make sure there is a load.
watch -n 2 aticonfig --adapter=all --odgt
here is a couple of commands that I have in a file that I always use.
aticonfig --od-enable
aticonfig --adapter=all --od-setclocks=920,400
aticonfig --adapter=all --odgc
DISPLAY=:0.1 aticonfig --pplib-cmd "set fanspeed 0 70"
DISPLAY=:0.3 aticonfig --pplib-cmd "get fanspeed 0"
for i in 0 1 2 3 4; do DISPLAY=:0.$i aticonfig --pplib-cmd "get fanspeed 0"; done
You could write a script that parses the output of aticonfig and run it every x seconds. For example, will give you the load. If it's not 99%, card is not used...
Code:
aticonfig --adapter=ID --odgc | grep 'GPU load' | awk '{ print $4; }'
So I made this linuxcoin distro to run 6 5830s on a msi870-gd65 & gd70. My start.sh is pretty simple but I run into problems.
In build 1 I ran 3 copies of CGMiner with two cards on each. Woke up to 2 copies offline and one card dead. So I went to 1 copy. Higher hash rate, but what I want to know is how I can make something that will dectect when the cards temp reaches a low level and restart the os. Any ideas?
In build 1 I ran 3 copies of CGMiner with two cards on each. Woke up to 2 copies offline and one card dead. So I went to 1 copy. Higher hash rate, but what I want to know is how I can make something that will dectect when the cards temp reaches a low level and restart the os. Any ideas?
Jump to: