Have issues with Knc Neptune? Full troubleshooting guide here!
http://fuk.io/knc-neptune-setup-guide-review-and-troubleshooting-35-terahash-bitcoin-miner/
Most important fails of kncs:
1. Board doesnt see miners
This is due ot mollex not set right. Miner doesnt need electricty to be seen so PSU can be even turned off. I know this sounds odd as the task seems simple but for some reason you need to sometimes really push it hard to connect. It seems like in some cases literallyless than 1mm is missing for them to easily connect.
2. Board sees miners but they run slower than should
There can be 2 reasons – to wack PSU or you will have to restart miner [fro mthe panel] few times to catch up
3. Miners are not on right mhz setup
I started having this lately and its really irritating. Cubes should be at 475mhz in usual mode yet sometimes show at 50mhz or 100mhz and mine.. really bad. DO NOT OVERCLOCK THEM IN ADVANCED. I have no idea whats the reason of this bug but all that fixes it is: try few restarts, reset to default [you will have to reconfigurate], rebtoot. Rinse n repeat till it works.
4. After a bit of mining my PSU goes down
This is due to common mistake of using same cable from PSU for 2 miners. 1 cable = 1 miner. Thats it!
Topic: My offsite troubleshooting KNC Neptune Guide (Read 896 times)
Jump to: