Topic: New Member (and question about the new Blade Erupters) (Read 516 times)
Thanks!
Thanks and good luck in getting your blade sorted. 
You can't buy that on its own isn't it? I only see it come with it if you get 10 Blades of the same order.
I've seen a few on eBay, but I wouldn't spend the money just for the convenience, especially if you've already got things up and running.
You can't buy that on its own isn't it? I only see it come with it if you get 10 Blades of the same order.
I suggest you wait till tomorrow. You seem to have tried everything already.
BTW, what is the Backplane for? I never got that so I want to know what it is for. Thanks
BTW, what is the Backplane for? I never got that so I want to know what it is for. Thanks
It's just a 10 slot circuit board that the V2 models can plug into. It's cleaner then building your own mounting gear and makes the wiring a lot easier IMHO. No real technical advantage I suppose, but I like it.
I suggest you wait till tomorrow. You seem to have tried everything already.
BTW, what is the Backplane for? I never got that so I want to know what it is for. Thanks
BTW, what is the Backplane for? I never got that so I want to know what it is for. Thanks
Howdy everyone -- can't post in the regular forums yet (was going to ask in Doggie's thread), so I thought I'd both say hi and ask here. I've been working quite a bit with the new Blade Erupters, but one of my blades doesn't seem to work. I've tried the following:
1) Moved it to other backplane slots that I've had working blades in. No joy.
2) Moved it from the backplane to a regular molex connector that is working with an older version blade. Still no joy.
3) Did a hardware reset and ran through the two above tests. No j....
4) Put a multi-meter on it, and zeros.
I'm working with the vendor to get a replacement, but that won't happen before tomorrow, so does anyone have anything else they could suggest? Any insight would be appreciated.
Thanks,
~N
1) Moved it to other backplane slots that I've had working blades in. No joy.
2) Moved it from the backplane to a regular molex connector that is working with an older version blade. Still no joy.
3) Did a hardware reset and ran through the two above tests. No j....
4) Put a multi-meter on it, and zeros.
I'm working with the vendor to get a replacement, but that won't happen before tomorrow, so does anyone have anything else they could suggest? Any insight would be appreciated.
Thanks,
~N
Jump to: